Manual Rotel RT12 (page 3 of 20) (English)

489959

Zoom out

Zoom in

1/20

English

WARNING: There are no user serviceable parts inside. Refer all servicing to qualified service

personnel.

WARNING: To reduce the risk of fire or electric shock, do not expose the unit to moisture or water.

Do not expose the unit to dripping or splashing. Do not place objects filled with liquids, such as vases,

on the unit. Do not allow foreign objects to get into the enclosure. If the unit is exposed to moisture,

or a foreign object gets into the enclosure, immediately disconnect the power cord from the wall. Take

the unit to a qualified service person for inspection and necessary repairs.

Read all the instructions before connecting or operating the component.

Keep this manual so you can refer to these safety instructions.

Heed all warnings and safety information in these instructions and on the product itself. Follow all

operating instructions.

Clean the enclosure only with a dry cloth or a vacuum cleaner.

Do not use this unit near water.

You must allow a minimum 10 cm or 4 inches of unobstructed clearance around the

unit.

Do not place the unit on a bed, sofa, rug, or similar surface that could block the ventilation openings.

If the unit is placed in a bookcase or cabinet, there must be ventilation of the cabinet to allow proper

cooling.

Keep the component away from radiators, heat registers, stoves, or any other appliance that

produces heat.

WARNING: The rear panel power

cord connector is the mains power

disconnect device. The apparatus must

be located in an open area that allows

access to the cord connector.

The unit must be connected to a

power supply only of the type

and voltage specified on the

rear panel. (USA: 120 V/60Hz,

EC: 230V/50Hz)

Connect the component to the power

outlet only with the supplied power supply cable or an exact equivalent. Do not modify the supplied

cable. A polarized plug has two blades, with one wider than the other. A grounding plug has two blades

plus a third grounding prong. These are provided for your safety. Do not defeat grounding and/or

polarization safety provisions. If the supplied plug does not fit your outlet, please consult an electrician

for replacement of the obsolete outlet. Do not use extension cords.

The main plug of the power cord set is a disconnect device of the apparatus. In order to completely

disconnect the apparatus from the supply mains, the main plug of the power cord set should be

unplugged from the mains (AC) outlet. The stand-by LED indicator will not be lit up to show the power

cord is unplugged. The disconnect device shall remain readily operable.

Do not route the power cord where it will be crushed, pinched, bent, exposed to heat, or damaged

in any way. Pay particular attention to the power cord at the plug and where the cord exits the back

of the unit.

The power cord should be unplugged from the wall outlet during a lightning storm or if the unit is to

be left unused for a long period of time.

Use only accessories specified by the manufacturer.

Use only with a cart, stand, rack, bracket or shelf system recommended by Rotel. Use

caution when moving the unit in a stand or rack to avoid injury from a tip-over.

Immediately stop using the component and have it inspected and/or serviced by a

qualified service agency if:

• Thepowersupplycordorplughasbeendamaged

• Objectshavefallenorliquidhasbeenspilledintotheunit

• Theunithasbeenexposedtorain

• Theunitshowssignsofimproperoperation

• Theunithasbeendroppedordamagedinanyway

The batteries in remote control shall not be exposed to excessive heat such as sunshine, fire or the

like.

Important Safety Instructions

NETWORK AUX FM DAB i-RADIO

POWER

RT-12

PUSH SELECT

QUEUE

PLAY

BACK REPLY

PAUSESTOP

SKIP +

1 2 3

4 5 6

7 8 9

MEMORY0

SKIP

Notice

The rear mini USB connection should be handled by authorized persons only.

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

•Reorientorrelocatethereceivingantenna.(TV,radio,etc.)

•Increasetheseparationbetweentheequipmentandreceiver

•Connecttheequipmenttoanoutletoncircuitdifferentfromthattowhichthereceiveris

connected.

•Consultthedealeroranexperiencedradio/TVtechnicianforadditionalhelp.

Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following to conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna installer’s attention to

Article 820-40 of the NEC. This provides guidelines for proper grounding and, in particular , speciﬁes

that the cable ground shall be connected to the grounding system of the building, as close to the point

of cable entry as practical. See installation diagram.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

interference in a residential installation. This equipment generates and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause interference to

radio or TV communications. There is no guarantee that interference will not occur in a particular

installation. If this equipment does cause interference to radio or television reception, which can be

determined by turning the equipment off and on, try to correct the interference by one or more of

the following measures:

•Reorientorrelocatethereceivingantenna.

•Increasetheseparationbetweentheunitandthetelevisiontuner.

•ConnecttheunittoanACpoweroutletonadifferentelectricalcircuit.

•ConsultyourauthorizedRotelretailerforassistance.

Hi, sontec electronics have just fitted me a new streaming module into my rotel RT12 and I need to know how to get internet radio, put in my wifi key and conected to my router but just get the message pura vida 106.3fm Buffering 0% please help Submitted on 10-10-2022 at 21:10
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Rotel RT12 in the language / languages: English as an attachment in your email.

The manual is 2,09 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Rotel RT12 Manual

Product: