579412
14
Zoom out
Zoom in
Previous page
1/24
Next page
06 GB
4. MAINTENANCE AND CLEANING
Before cleaning the hob, ensure the appliance has cooled down.
Remove the plug from the socket or (if connected directly) switch off
the electricity supply.
Cleaning and user maintenance shall not be made by children without
supervision.
Never use abrasives, corrosive detergents, bleaching agents or
acids. Avoid any acid or alkaline substances (lemon, juice, vinegar
etc.) on the enamelled, varnished or stainless steel sections.
When cleaning the enamelled, varnished or chrome sections, use
warm soapy water or a non caustic detergent. For stainless steel use
an appropriate cleaning solution.
The burners can be cleaned with soapy water. To restore their original
shine, use a household stainless steel cleaner. After cleaning, dry the
burners and replace.
It is important the Burners are replaced correctly.
"WARNING- Do not use a steam cleaner to clean the hob.
Avoid spillages, as anything which falls on to the hob surface will
quickly burn and will make cleaning more difficult.
• It is advisable to keep away from the hob all substances which are
liable to melt, such as plastic items, sugar, or sugar-based products.
MAINTENANCE:
- Place a few drops of the specialized cleaning product on the hob
surface.
- Rub any stubborn stains with a soft cloth or with slightly damp kitchen
paper.
- Wipe with a soft cloth or dry kitchen paper until the surface is clean.
If there are still some stubborn stains:
- Place a few more drops of specialized cleaning fluid on the surface.
- Scrape with a scraper, holding it at an angle of 30° to the hob, until the
stains disappear.
- Wipe with a soft cloth or dry kitchen paper until the surface is clean.
- Repeat the operation if necessary.
A scraper with a razor blade will not damage the surface, as long as it
is kept at an angle of 30°.
Never leave a scraper with a razor blade within the reach of
children.
A FEW HINTS:
Frequent cleaning leaves a protective layer which is essential to
prevent scratches and wear. Make sure that the surface is clean
before using the hob again. To remove marks left by water, use a
few drops of white vinegar or lemon juice. Then wipe with
absorbent paper and a few drops of specialized cleaning fluid. The
glass ceramic surface will withstand scraping from flat bottomed
cooking vessels, however, it is always better to lift them when
moving them from one zone to another.
5. AFTERCARE
Before calling out a Service Engineer please check the following:
that the plug is correctly inserted and fused;
that the gas supply is not faulty.
If the fault cannot be detected:
Switch off the appliance and call the After Service Centre.
DO NOT TAMPER WITH THE APPLIANCE.
This appliance is marked according to the European
directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you
will help prevent potential negative consequences for
the environment and human health, which could
otherwise be caused by inappropriate waste handling
of this product.
The symbol on the product indicates that this product may not be
treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment.
Disposal must be carried out in accordance with local environmental
regulations for waste disposal.
For more detailed information about treatment, recovery and recycling
of this product, please contact your local city office, your household
waste disposal service or the shop where you purchased the product.
6. PROTECTION OF THE ENVIRONMENT
Declaration of compliance: This equipment, in the parts intended to
come into contact with food, complies with the regulations laid down in
EEC directives 89/109.
Appliance complies with European Directives 2006/95/EC,
2004/108/EC and 2009/142/EC and subsequent
amendments.
This appliance has been designed for non-professional, i.e. domestic, use.
Table 1
PLV6S
Auxiliary Burner (AUX)
Semirapid Burner (SR)
Rapid burner (R)
UltraRapid Burner (UR)
Electric Plate
Flame failure device
G 20/20 mbar (N.G) (I/h)
G30/G31 28-30/37 mbar (LPG) (g/h)
Installation Class
Voltage (V) / Frequency (Hz)
Electrical power (W)
İgnition
Product dimension LxD (mm)
Gas Power (kW)
YES
8,75
833
636
3
1
595 x 510 745 x 510
220-240 V / 50-60 Hz
6,25
454
3
1500
12,0
1143
873
3
1
8,75
833
636
3
1
700 x 510
Type
Models
Installed Gas type / power
4 Gas
1
1
1
1
-
3 Gas+1E
1
1
-
1
5Gas
-
2
2
1
1
PLV7S
-
4Gas
1
1
1
1
-
BUILT IN HOBS
Alternative injector kit for LPG gas available in the packaging
Gas Power (kW)
8,75 6,25 12,08,75
Rated power input
YES
595
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rosieres RTF 40 E IN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rosieres RTF 40 E IN in the language / languages: French as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info