22 23
CLEANING
ATTENTION: Always pull the mains plug rst before cleaning!
Prior to cleaning of appliance or equipment please carefully wash you hands.
Prior and after each use clean the appliance’s surface with a moist cloth and mild detergent (no
abrasive cleaners or solvents). Should any liquid get into the appliance, under no circumstances
connect the appliance to the mains plug, but contact your service point.
Clean thoroughly all equipment (containers, lids, jars, etc.) and let it dry completely.
For cleaning the equipment in your dishwasher use the top rack only.
TECHNICAL DATA
Suction system with safety liquid-collecting tray, equipped with a lubrication-free piston-driven
rotary depressor. Casing made of antistatic ABS synthetic resin of rst quality.
automatic suction
automatic and manual sealing voltage/wattage:
230 V~ 50 Hz · 320 W
pump air ow rate: 10 l/min (approx.) dimensions : L x D x H: 29 cm x 14 cm x 9 cm
pump vacuum level: 60 cm/Hg / - 0.8 bar (approx.) weight: 2 kg
TROUBLESHOOTING
Appliance not working
• Check the correct tting of the wall plug. Check the socket by plugging in another appliance.
• To start the vacuum sealing process press the ON button while additionally pressing down
on the area marked PUSH at the cover to generate sufcient pressure.
• In case of overheating the appliance switches-off automatically. In this case let it cool down
for
15 minutes.
• Check whether cable or plug show damage. If yes - do not operate the appliance!
Vacuum sealer does not seal the rst edge of the cut-off plastic bag
• Check whether the cut side of the bag was positioned correctly
(according to paragraph
„Vacuum sealing with plastic bags and rolls“).
Appliance does not create a complete vacuum inside the plastic bag
• For a correct sealing process the open end of the bag must completely extend into the
vacuum chamber
(9).
• Check the sealing bar (10) as well as the gaskets (7) + (8) for dirt on them.
Clean them and put them in correct position again.
• Check the plastic bag for holes.
Appliance does not seal correctly
• In case the sealing bar (10) gets too hot and the bag melts, open the cover (5) and let the bar
cool down for some minutes.
• This appliance is produced in compliance with current safety standards. In the event of
overheating, the appliance gets switched-off automatically. Leave it to cool down for
15
minutes before starting the vacuum sealing cycle again.
Appliance does not create a complete vacuum inside the container
• Reposition the connection hose (12), one side into the hose port (6), the other side into the lid.
• Do not ll the container completely but leave a space of at least 3 cm.
• Make sure the arrow at the container’s lid points to "VACUUM".
• Use a vacuuming cap of the correct size.
• Check if vacuuming cap is worn out or damaged.
• When putting the vacuuming cap onto the container’s lid twist it to get a rmer, better t.
• Let liquids cool down before vacuum sealing.
