21
WARNING: Hazard of injury and burns!
• The surfaces of appliance, glass jug, lid, lid insert, tea infuser
as well as the liquids are getting hot during use.
• Hot surfaces firstly stay hot after switch-off.
• Do not overfill the jug as hot liquid might spill over!
Operating the appliance
1. Connecting the base unit
• Connect the power plug to a properly fused socket.
• The appliance switches into selection-mode.
• A signal tone sounds and the display shows programme 1 “Herbal”.
Note: If no further button is activated within 1 minute, the appliance will switch over to standby mode and the
display goes out.
2. Filling up with water and placing the cover
• Lift the glass jug from the base unit.
• Fill the glass jug with cold tap water. Observe the "MIN" and "MAX" marking. See to it that no water will spill on
the central base or the underside of the jug.
• Put the lid on the glass jug. Ensure a proper fitting.
• Fit the lid insert for the tea infuser in the jug’s lid (position OPEN) and screw it to the right (CLOSE position).
• Put the lid on the glass jug.
• Place the glass jug on the base unit.
3. Selecting programme/function
Note: The standby mode can be switched to selection-mode by pressing any button (except BOILING button).
• The display shows programme selection 1 “Herbal”.
• Choose between the different preset programs by pressing the “MENU” button.
• It is possible to switch between the display of temperature and time by pressing the “TIME/TEMP“ button.
• The display will return to show the temperature after about 4 seconds.
Note: In case the appliance is in standby mode, lifting the jug will put it into selection-mode. The display shows
programme 1 "Herbal".