714008

Rommelsbacher CT3405IN Manual

26
Zoom out
Zoom in
Previous page
1/28
Next page
26
Error codes
The electronic control features several internal monitoring functions. If an error occurs, the power supply
will be quit and an error code will appear on the display, in addition there is an acoustic signal during the
first 60 seconds.
Error code table:
E0 Pot recognition: Each cooking zone features a sensor which recognizes whether there is a vessel
on the cooking zone. If no suitable vessel is recognized on the cooking zone after switch-on, the
display will show “E0”.
Self help: Place a pot on the cooking zone within 45 seconds; otherwise the electronics will switch
the unit into the standby mode. (Also refer to point “Getting acquainted with your appliance“)
E1 Electronic error: A short-circuit has occurred in an electronic circuit of the appliance.
Self-help: Not possible – the appliance must be forwarded to the customer service at any rate.
E2 Temperature sensor: The temperature sensor below the glass ceramic plate provides an undue value.
Self-help: Allow the appliance to stand for a while in order to adjust to the surrounding temperature.
E3 Electronic control of over-voltage: An Error has occurred in an electronic circuit of the appliance
due to excessively high voltage (> 270 V~).
Self-help: Make sure the appliance is connected to the voltage indicated on the rating label.
E4 Electronic control of under-voltage: An error has occurred in an electronic circuit of the appliance
due to excessively low voltage (< 160 V~).
Self-help: Make sure the appliance is connected to the voltage indicated on the rating label.
E5 Overheating protection (“power level” mode): During the “power level” mode the temperature
on the cooktop exceeds the maximum tolerable value of 200 °C (e. g. due to hot oil or fat or an
empty pot or any other metal object while the appliance is switched on).
Self-help: Eliminate the cause of overheating. Once the cooktop has cooled the appliance can be put
into operation again. Afterwards, use the “temperature level” mode for constant temperatures
above 200 °C.
E6 Inside temperature: The inside of the appliance is too warm (e. g. due to hindered air supply,
blocked or defective fan or excessive ambient temperature).
Self-help: Clean the ventilation holes or remove any impurities that might be there, improve the
ventilation.
NOTE: For all displayed error codes, except of “E0”, it is necessary to manually reset the control
by pulling the mains plug or separating the unit from the mains supply.
… 26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rommelsbacher CT3405IN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rommelsbacher CT3405IN in the language / languages: English, German as an attachment in your email.

The manual is 2,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info