EN-29
White Balance
This sets the white balance for a variety of lighting conditions and permits images to be
captured that approach the conditions that are seen by the human eye.
* [ Blank ] Auto
* [ ] Incandescent
* [ ] Fluorescent 1
* [ ] Fluorescent 2
* [ ] Daylight
* [ ] Cloudy
* [ ] Manual
Sharpness
This sets the sharpness of the image that will be captured.
* Hard / Normal / Soft
Saturation
This sets the saturation of the image that will be captured.
* High / Normal / Low
Metering
This sets the metering method for calculating the exposure.
* [ ] Average: Averages the light metered from the entire frame, but gives greater weight
to the subject matter at the center.
* [ ] Spot: A very small portion of the center of the screen is measured to calculate the
correct exposure.
* [ ] Multi: The entire area of the screen is measured, and the exposure is calculated.
Flash Offset
This sets the flash strength. The flash power becomes strong when selecting “+” values. The
flsh power becomes soft when selecting “-“ values.
* +2 / +1 / 0 / -1 / -2
Manual WB
This manually sets the white balance and stores it. Use of this is convenient when the white
balance does not offer a good match.
Before selecting [Execute] and before taking your image, place a white paper in the scene and
set the white balance manually.
* Cancel / Execute
Capture Mode
This sets the recording method at the time of capturing images.
* [ ] Single: Captures one image at a time.
* [ ] Continuous: Permits continuous capture of up to 3 images.
* [ ] AEB: Permits 3 consecutive images in the order of standard exposure,
underexposure and overexposure compensation.
* [ ] Burst: Permits continuous photography while keeping the shutter button pressed
down. As long as you hold the shutter button pressed, pictures are captured until
the memory capacity is exhausted.
* [ ] Cont.flash: The “Series + flash” capture mode lets you shoot a sequence of 3
pictures with flash.
* [ ]
Pre-Shot: Pre-shot helps you get the background you want, even if you need to ask
someone else to record the image for you. Basically, Pre-shot is a two-step process.
1
2
