OD/DS 0 AutoWah
L out
R out
Pan L
Pan R
L in
R in
Auto Wah
Overdrive/
Distortion
Amp
Simulator
2-Band
EQ
Parameter Value Explanation
Drive Switch OFF, ON Turns overdrive/distortion on/o
Drive Type OVERDRIVE,
DISTORTION Type of distortion
Drive 0–127 Degree of distortion
Also changes the volume.
Tone 0–127 Sound quality of the Overdrive eect
Amp Switch OFF, ON Turns the Amp Simulator on/o.
Amp Type SMALL, BUILT-IN,
2-STACK, 3-STACK
Type of guitar amp
SMALL: Small amp
BUILT-IN: Single-unit type amp
2-STACK: Large double stack amp
3-STACK: Large triple stack amp
AutoWah Switch OFF, ON Wah on/o
AutoWah Mode LPF, BPF
Filter type
LPF: The wah eect will be applied over a wide frequency
range.
BPF: The wah eect will be applied over a narrow frequency
range.
AutoWah Manual 0–127 Center frequency at which the wah eect is applied
AutoWah Peak 0–127
Width of the frequency region at which the wah eect
is applied
Increasing this value will make the frequency region
narrower.
AutoWah Rate (sync sw) OFF, ON Synchronize to the tempo of the DAW if this is ON.
AutoWah Rate (Hz) 0.05–10.00 [Hz]
Frequency of modulation
AutoWah Rate (note) Note
& “Note”
AutoWah Depth 0–127 Depth at which the wah eect is modulated
AutoWah Balance D100: 0W–D0: 100W
Adjusts the volume balance between the sound that is
sent through the wah (W) and the sound that is not sent
through the wah (D).
Low Gain -15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain -15–+15 [dB] Amount of boost/cut for the high-frequency range
Level 0–127 Output Level