Manual Roland Micro Cube Bass RX (page 4 of 52) (English, German, Dutch, French, Italian, Portuguese, Spanish)

537789

Zoom out

Zoom in

1/52

IMPORTANT NOTES

Power Supply: Use of Batteries

• Do not connect this unit to same electrical outlet that is

being used by an electrical appliance that is controlled

by an inverter (such as a refrigerator, washing machine,

microwave oven, or air conditioner), or that contains

a motor. Depending on the way in which the electrical

appliance is used, power supply noise may cause this unit

to malfunction or may produce audible noise. If it is

not practical to use a separate electrical outlet, connect

a power supply noise filter between this unit and the

electrical outlet.

• The AC adaptor will begin to generate heat after long

hours of consecutive use. This is normal, and is not

a cause for concern.

• The use of an AC adaptor is recommended as the unit’s

power consumption is relatively high. Should you prefer

to use batteries, please use the alkaline type.

• When installing or replacing batteries, always turn off the

power on this unit and disconnect any other devices you

may have connected. This way, you can prevent

malfunction and/or damage to speakers or other devices.

• Before connecting this unit to other devices, turn off the

power to all units. This will help prevent malfunctions

and/or damage to speakers or other devices.

Placement

• Using the unit near power amplifiers (or other equipment

containing large power transformers) may induce hum.

To alleviate the problem, change the orientation of this

unit; or move it farther away from the source of inter-

ference.

• This device may interfere with radio and television

reception. Do not use this device in the vicinity of such

receivers.

• Noise may be produced if wireless communications

devices, such as cell phones, are operated in the vicinity of

this unit. Such noise could occur when receiving or initi-

ating a call, or while conversing. Should you experience

such problems, you should relocate such wireless devices

so they are at a greater distance from this unit, or switch

them off.

• Do not expose the unit to direct sunlight, place it near

devices that radiate heat, leave it inside an enclosed

vehicle, or otherwise subject it to temperature extremes.

Also, do not allow lighting devices that normally are used

while their light source is very close to the unit (such as

a piano light), or powerful spotlights to shine upon the

same area of the unit for extended periods of time.

Excessive heat can deform or discolor the unit.

• When moved from one location to another where the

temperature and/or humidity is very different, water

droplets (condensation) may form inside the unit. Damage

or malfunction may result if you attempt to use the unit in

this condition. Therefore, before using the unit, you must

allow it to stand for several hours, until the condensation

has completely evaporated.

• Do not allow rubber, vinyl, or similar materials to remain

on the unit for long periods of time. Such objects can

discolor or otherwise harmfully affect the finish.

• Do not paste stickers, decals, or the like to this instrument.

Peeling such matter off the instrument may damage the

exterior finish.

• Depending on the material and temperature of the surface

on which you place the unit, its rubber feet may discolor

or mar the surface.

You can place a piece of felt or cloth under the rubber feet

to prevent this from happening. If you do so, please make

sure that the unit will not slip or move accidentally.

Maintenance

• For everyday cleaning wipe the unit with a soft, dry cloth

or one that has been slightly dampened with water.

To remove stubborn dirt, use a cloth impregnated with

a mild, non-abrasive detergent. Afterwards, be sure to

wipe the unit thoroughly with a soft, dry cloth.

• Never use benzine, thinners, alcohol or solvents of any

kind, to avoid the possibility of discoloration and/or

deformation.

Additional Precautions

• Use a reasonable amount of care when using the unit’s

buttons, sliders, or other controls; and when using its jacks

and connectors. Rough handling can lead to malfunctions.

• When connecting/disconnecting all cables, grasp the

connector itself—never pull on the cable. This way you

will avoid causing shorts, or damage to the cable’s internal

elements.

• To avoid disturbing your neighbors, try to keep the unit’s

volume at reasonable levels. You may prefer to use

headphones, so you do ot need to be concerned about

those around you (especially when it is late at night).

• When you need to transport the unit, package it in the box

(including padding) that it came in, if possible. Otherwise,

you will need to use equivalent packaging materials.

• Some connection cables contain resistors. Do not use

cables that incorporate resistors for connecting to this unit.

The use of such cables can cause the sound level to be

extremely low, or impossible to hear. For information on

cable specifications, contact the manufacturer of the cable.

MCB-RX_r_e.book Page 4 Thursday, January 10, 2008 1:00 PM

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Roland Micro Cube Bass RX in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 8,87 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Roland Micro Cube Bass RX Manual

Product: