Manual Roland Juno Di (page 6 of 136) (English)

499471

Zoom out

Zoom in

1/136

IMPORTANT NOTES

Power Supply: Use of Batteries

301

• Do not connect this unit to same electrical outlet that is being used

by an electrical appliance that is controlled by an inverter (such as a

refrigerator, washing machine, microwave oven, or air conditioner),

or that contains a motor. Depending on the way in which the

electrical appliance is used, power supply noise may cause this unit

to malfunction or may produce audible noise. If it is not practical to

use a separate electrical outlet, connect a power supply noise filter

between this unit and the electrical outlet.

302

• The AC adaptor will begin to generate heat after long hours of

consecutive use. This is normal, and is not a cause for concern.

303a

• The use of an AC adaptor is recommended as the unit’s power

consumption is relatively high. Should you prefer to use batteries,

please use the nickel-metal hydride type.

304a

• When installing or replacing batteries, always turn off the power on

this unit and disconnect any other devices you may have connected.

This way, you can prevent malfunction and/or damage to speakers or

other devices.

307

• Before connecting this unit to other devices, turn off the power to all

units. This will help prevent malfunctions and/or damage to speakers

or other devices.

Add

• If you’re using batteries, disconnect the AC adaptor from this unit.

Add

• If batteries are installed, disconnecting or reconnecting the power

cord at the AC outlet or disconnecting the DC plug from the unit’s

rear panel while the power is on will cause the power to turn off. You

must turn off the power before you connect or disconnect the power

cord or AC adaptor.

Placement

351

• Using the unit near power amplifiers (or other equipment containing

large power transformers) may induce hum. To alleviate the

problem, change the orientation of this unit; or move it farther away

from the source of interference.

352a

• This device may interfere with radio and television reception. Do not

use this device in the vicinity of such receivers.

352b

• Noise may be produced if wireless communications devices, such as

cell phones, are operated in the vicinity of this unit. Such noise could

occur when receiving or initiating a call, or while conversing. Should

you experience such problems, you should relocate such wireless

devices so they are at a greater distance from this unit, or switch

them off.

354a

• Do not expose the unit to direct sunlight, place it near devices that

radiate heat, leave it inside an enclosed vehicle, or otherwise subject

it to temperature extremes. Excessive heat can deform or discolor the

unit.

355b

• When moved from one location to another where the temperature

and/or humidity is very different, water droplets (condensation) may

form inside the unit. Damage or malfunction may result if you

attempt to use the unit in this condition. Therefore, before using the

unit, you must allow it to stand for several hours, until the

condensation has completely evaporated.

358

• Do not allow objects to remain on top of the keyboard. This can be

the cause of malfunction, such as keys ceasing to produce sound.

360

• Depending on the material and temperature of the surface on which

you place the unit, its rubber feet may discolor or mar the surface.

You can place a piece of felt or cloth under the rubber feet to prevent

this from happening. If you do so, please make sure that the unit will

not slip or move accidentally.

Maintenance

401a

• For everyday cleaning wipe the unit with a soft, dry cloth or one that

has been slightly dampened with water. To remove stubborn dirt,

use a cloth impregnated with a mild, non-abrasive detergent.

Afterwards, be sure to wipe the unit thoroughly with a soft, dry cloth.

402

• Never use benzine, thinners, alcohol or solvents of any kind, to avoid

the possibility of discoloration and/or deformation.

Repairs and Data

452

• Please be aware that all data contained in the unit’s memory may be

lost when the unit is sent for repairs. Important data should always

be backed up on a USB memory, or written down on paper (when

possible). During repairs, due care is taken to avoid the loss of data.

However, in certain cases (such as when circuitry related to memory

itself is out of order), we regret that it may not be possible to restore

the data, and Roland assumes no liability concerning such loss of

data.

Additional Precautions

551

• Please be aware that the contents of memory can be irretrievably lost

as a result of a malfunction, or the improper operation of the unit. To

protect yourself against the risk of loosing important data, we

recommend that you periodically save a backup copy of important

data you have stored in the unit’s memory on a USB memory.

552

• Unfortunately, it may be impossible to restore the contents of data

that was stored in the unit’s memory or on a USB memory once it has

been lost. Roland Corporation assumes no liability concerning such

loss of data.

553

• Use a reasonable amount of care when using the unit’s buttons,

sliders, or other controls; and when using its jacks and connectors.

Rough handling can lead to malfunctions.

554

• Never strike or apply strong pressure to the display.

556

• When connecting / disconnecting all cables, grasp the connector

itself—never pull on the cable. This way you will avoid causing

shorts, or damage to the cable’s internal elements.

558a

• To avoid disturbing your neighbors, try to keep the unit’s volume at

reasonable levels. You may prefer to use headphones, so you do not

need to be concerned about those around you (especially when it is

late at night).

559a

• When you need to transport the unit, package it in the box (including

padding) that it came in, if possible. Otherwise, you will need to use

equivalent packaging materials.

561

• Use only the specified expression pedal (EV-5; sold separately). By

connecting any other expression pedals, you risk causing

malfunction and/or damage to the unit.

562

• Some connection cables contain resistors. Do not use cables that

incorporate resistors for connecting to this unit. The use of such

cables can cause the sound level to be extremely low, or impossible

to hear. For information on cable specifications, contact the

manufacturer of the cable.

566a

• The usable range of D Beam controller will become extremely small

when used under strong direct sunlight. Please be aware of this

when using the D Beam controller outside.

566b

• The sensitivity of the D Beam controller will change depending on

the amount of light in the vicinity of the unit. If it does not function as

you expect, adjust the sensitivity as appropriate for the brightness of

your location.

JUNO-Di_e.book 6 ページ２００９年６月２２日　月曜日　午前９時２３分

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Roland Juno Di in the language / languages: English as an attachment in your email.

The manual is 13,4 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Roland Juno Di Manual

Product: