527442
16
Zoom out
Zoom in
Previous page
1/144
Next page
16
Panel Descriptions
(continued)
fig.unit02-e.eps
CD Tray
This is where you insert a CD.
“Inserting a CD” (Page 28)
Emergency Eject Hole
You can use this to remove the CD in case of
emergency. Normally, it is not used.
“If You are Unable to Eject the Disc” (Page 29)
fig.unit02-e.eps
EXT MIC Jacks (XLR type, MONO jack)
Connect external mics to these jacks.
This connector can supply phantom power.
“Connecting an External Mic for Recording” (Page 44)
* This instrument is equipped with balanced (XLR) type
jacks. Wiring diagrams for these jacks are shown below.
Make connections after first checking the wiring
diagrams of other equipment you intend to connect.
EXT MIC Jacks (R jack, L/MONO jack)
Connect external mics to these jacks.
If you’re using only one mic, connect it to the L/
MONO jack.
“Connecting an External Mic for Recording” (Page 44)
Ground Terminal
Connect this to an external electrical ground.
Right Side Panel
Left Side Panel
Depending on the circumstances of a particular setup,
you may experience a discomforting sensation, or
perceive that the surface feels gritty to the touch when
you touch this device, microphones connected to it,
or the metal portions of other objects, such as guitars.
This is due to an infinitesimal electrical charge, which
is absolutely harmless. However, if you are concerned
about this, connect the ground terminal (see figure)
with an external ground. When the unit is grounded,
a slight hum may occur, depending on the particulars
of your installation. If you are unsure of the connection
method, contact the nearest Roland Service Center, or
an authorized Roland distributor, as listed on the
“Information” page
Unsuitable places for connection
Water pipes (may result in shock or electrocution)
Gas pipes (may result in fire or explosion)
Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
CD-2i_e.book 16 ページ 2010年3月15日 月曜日 午前10時15分
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Roland CD-2I at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Roland CD-2I in the language / languages: English as an attachment in your email.

The manual is 10,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Roland CD-2I

Roland CD-2I Quick start guide - English - 2 pages

Roland CD-2I Quick start guide - Dutch - 2 pages

Roland CD-2I User Manual - Dutch - 144 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info