Manual Roland CD-2I (page 11 of 144) (English)

527442

Zoom out

Zoom in

1/144

Advanced UsesRecording Listening Deleting Creating a CD Editing an SD Appendices

Convenient

Functions

Information

/ Display

Checking /

Preparations

IMPORTANT NOTES

301

●

Do not connect this unit to same electrical outlet that is

being used by an electrical appliance that is controlled by

an inverter (such as a refrigerator, washing machine,

microwave oven, or air conditioner), or that contains a

motor. Depending on the way in which the electrical

appliance is used, power supply noise may cause this unit

to malfunction or may produce audible noise. If it is not

practical to use a separate electrical outlet, connect a

power supply noise filter between this unit and the

electrical outlet.

302

●

The AC adaptor will begin to generate heat after long

hours of consecutive use. This is normal, and is not a

cause for concern.

303a

●

The use of an AC adaptor is recommended as the unit’s

power consumption is relatively high. Should you prefer

to use batteries, please use the alkaline type or Nickel-

hydride type.

304a

●

When installing or replacing batteries, always turn off the

power on this unit and disconnect any other devices you

may have connected. This way, you can prevent

malfunction and/or damage to speakers or other devices.

306a

●

A battery was installed in the unit before it left the factory.

The life of this battery may be limited, however, since its

primary purpose was to enable testing.

307

●

Before connecting this unit to other devices, turn off the

power to all units. This will help prevent malfunctions

and/or damage to speakers or other devices.

330

●

Even if batteries are installed, the power will turn off if you

connect or disconnect the power cord from the AC outlet

while the power is turned on, or if you connect or

disconnect the AC adaptor from the product. When this

occurs, unsaved data may be lost. You must turn off the

power before you connect or disconnect the power cord

or AC adaptor.

351

●

Using the unit near power amplifiers (or other equipment

containing large power transformers) may induce hum.

To alleviate the problem, change the orientation of this

unit; or move it farther away from the source of

interference.

352a

●

This device may interfere with radio and television

reception. Do not use this device in the vicinity of such

receivers.

352b

●

Noise may be produced if wireless communications

devices, such as cell phones, are operated in the vicinity of

this unit. Such noise could occur when receiving or

initiating a call, or while conversing. Should you

experience such problems, you should relocate such

wireless devices so they are at a greater distance from this

unit, or switch them off.

354a

●

Do not expose the unit to direct sunlight, place it near

devices that radiate heat, leave it inside an enclosed

vehicle, or otherwise subject it to temperature extremes.

Excessive heat can deform or discolor the unit.

355b

●

When moved from one location to another where the

temperature and/or humidity is very different, water

droplets (condensation) may form inside the unit.

Damage or malfunction may result if you attempt to use

the unit in this condition. Therefore, before using the unit,

you must allow it to stand for several hours, until the

condensation has completely evaporated.

360

●

Depending on the material and temperature of the

surface on which you place the unit, its rubber feet may

discolor or mar the surface.

You can place a piece of felt or cloth under the rubber feet

to prevent this from happening. If you do so, please make

sure that the unit will not slip or move accidentally.

401a

●

For everyday cleaning wipe the unit with a soft, dry cloth

or one that has been slightly dampened with water. To

remove stubborn dirt, use a cloth impregnated with a

mild, non-abrasive detergent. Afterwards, be sure to wipe

the unit thoroughly with a soft, dry cloth.

402

●

Never use benzine, thinners, alcohol or solvents of any

kind, to avoid the possibility of discoloration and/or

deformation.

452

●

Please be aware that all data contained in the unit’s

memory may be lost when the unit is sent for repairs.

Important data should always be written down on paper

(when possible). During repairs, due care is taken to avoid

the loss of data. However, in certain cases (such as when

circuitry related to memory itself is out of order), we

regret that it may not be possible to restore the data, and

Roland assumes no liability concerning such loss of data.

551

●

Please be aware that the contents of memory can be

irretrievably lost as a result of a malfunction, or the

improper operation of the unit. To protect yourself against

the risk of loosing important data, we recommend that

you write down important data you have stored in the

unit’s memory on paper.

552

●

Unfortunately, it may be impossible to restore the

contents of data that was stored SD memory card, CD, or

in the unit’s memory once it has been lost. Roland

Corporation assumes no liability concerning such loss of

data.

553

●

Use a reasonable amount of care when using the unit’s

buttons, sliders, or other controls; and when using its jacks

and connectors. Rough handling can lead to

malfunctions.

554

●

Never strike or apply strong pressure to the display.

Power Supply: Use of Batteries

Placement

Maintenance

Repairs and Data

Additional Precautions

CD-2i_e.book 11 ページ２０１０年３月１５日　月曜日　午前１０時１５分

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Roland CD-2I in the language / languages: English as an attachment in your email.

The manual is 10,69 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Roland CD-2I

Roland CD-2I Quick start guide - English - 2 pages

Roland CD-2I Quick start guide - Dutch - 2 pages

Roland CD-2I User Manual - Dutch - 144 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Roland CD-2I Manual

Product: