527334
9
Zoom out
Zoom in
Previous page
1/148
Next page
7
Important Notes
Floppy Disk Handling
(Using Optional Floppy Disk Drive)
651
Floppy disks contain a plastic disk with a thin coating of
magnetic storage medium. Microscopic precision is required
to enable storage of large amounts of data on such a small
surface area. To preserve their integrity, please observe the
following when handling floppy disks:
Never touch the magnetic medium inside the disk.
Do not use or store floppy disks in dirty or dusty areas.
Do not subject floppy disks to temperature extremes
(e.g., direct sunlight in an enclosed vehicle).
Recommended temperature range: 10–50 degrees C
(50–122 degrees F).
Do not expose floppy disks to strong magnetic fields,
such as those generated by loudspeakers.
652
Floppy disks have a “write protect” tab which can protect the
disk from accidental erasure. It is recommended that the tab
be kept in the PROTECT position, and moved to the WRITE
position only when you wish to write new data onto the disk.
fig.DiskProtect.e.eps
653
The identification label should be firmly affixed to the disk.
Should the label come loose while the disk is in the drive, it
may be difficult to remove the disk.
654
Store all disks in a safe place to avoid damaging them, and to
protect them from dust, dirt, and other hazards. By using a
dirty or dust-ridden disk, you risk damaging the disk, as well
as causing the disk drive to malfunction.
USB Memory Handling
(Using Optional USB Memory)
704
When connecting USB memory, firmly insert it all the way in.
705
Do not touch the pins of the USB memory connector, or allow
them to become dirty.
708
USB memory is made using high-precision electronic
components, so please observe the following points when
handling it.
To prevent damage from static electrical charges,
discharge any static electricity that might be present in
your body before handling USB memory.
Do not touch the terminals with your fingers or any metal
object.
Do not bend or drop USB memory, or subject it to strong
impact.
Do not leave USB memory in direct sunlight or in
locations such as a closed-up automobile. (Storage
temperature: 0–50 degrees C)
Do not allow USB memory to become wet.
Do not disassemble or modify USB memory.
Addition
When connecting USB memory, position it horizontally with
the external memory connector and insert it without using
excessive force. The external memory connector may be
damaged if you use excessive force when inserting USB
memory.
Addition
Do not insert anything other than USB memory (e.g., wire,
coins, other types of device) into the external memory
connector. Doing so will damage the external memory
connector.
Addition
Do not apply excessive force to the connected USB memory.
Addition
If you will not be using USB memory for an extended period of
time, close the USB memory cover.
Handling the CDs (CD-ROMs)
(Using Optional CD Drive)
Add
When handling the discs, please observe the following.
Do not touch the encoded surface of the disc.
Do not use in dusty areas.
Do not leave the disc in direct sunlight or an enclosed
vehicle.(Storage temperature: 0–50 degrees C)
801
Avoid touching or scratching the shiny underside (encoded
surface) of the disc. Damaged or dirty CD-ROM discs may not
be read properly. Keep your discs clean using a commercially
available CD cleaner.
Add
Keep the disc in the case.
Add
Do not keep the disc in the CD drive for a long time.
Add
Do not put a sticker on the label of the disc.
Add
Wipe the disc with a soft and dry cloth radially from inside to
outside. Do not wipe along circumference.
Add
Do not use benzine, record cleaner spray or solvents of any
kind.
Add
Do not bend the disc. Bending discs may prevent proper
reading and writing of data, and may further result in
malfunction.
Copyright
852
This product can be used to record or duplicate audio or
visual material without being limited by certain technological
copy-protection measures. This is due to the fact that this
product is intended to be used for the purpose of producing
original music or video material, and is therefore designed so
that material that does not infringe copyrights belonging to
others (for example, your own original works) can be
recorded or duplicated freely.
853
Do not use this unit for purposes that could infringe on a
copyright held by a third party. We assume no responsibility
whatsoever with regard to any infringements of third-party
copyrights arising through your use of this unit.
Rear side of the disk
Write
(can write new data onto disk)
Protect
(prevents writing to disk)
Write Protect Tab
203
* GS ( ) is a registered trademark of Roland
Corporation.
Add
* XGlite ( ) is a registered trademark of Yamaha
Corporation.
220
* All product names mentioned in this document are
trademarks or registered trademarks of their
respective owners.
AT-100-300_e.book 7 ページ 2008年5月7日 水曜日 午後3時33分
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Roland AT300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Roland AT300 in the language / languages: English as an attachment in your email.

The manual is 19,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Roland AT300

Roland AT300 User Manual - Dutch - 144 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info