Manual Roland AD8 (page 4 of 28) (English, German)

23019

Zoom out

Zoom in

1/28

IMPORTANT NOTES

291a

In addition to the items listed under “USING THE UNIT SAFELY” on page 2–3, please read and observe the

following:

Power Supply: Use of Batteries

301

• Do not use this unit on the same power circuit with any

device that will generate line noise (such as an electric

motor or variable lighting system).

302

• The AC adaptor will begin to generate heat after long

hours of consecutive use. This is normal, and is not a cause

for concern.

303a

• The use of an AC adaptor is recommended as the unit’s

power consumption is relatively high. Should you prefer to

use batteries, please use the alkaline type.

304b

• Batteries should always be installed or replaced before

connecting any other devices. This way, you can prevent

malfunction and/or damage to speakers or other devices.

306b

• Batteries are supplied with the unit. The life of these

batteries may be limited, however, since their primary

purpose was to enable testing.

307

• Before connecting this unit to other devices, turn off the

power to all units. This will help prevent malfunctions

and/or damage to speakers or other devices.

Placement

351

• Using the unit near power amplifiers (or other equipment

containing large power transformers) may induce hum. To

alleviate the problem, change the orientation of this unit; or

move it farther away from the source of interference.

352a

• This device may interfere with radio and television

reception. Do not use this device in the vicinity of such

receivers.

352b

• Noise may be produced if wireless communications

devices, such as cell phones, are operated in the vicinity of

this unit. Such noise could occur when receiving or initi-

ating a call, or while conversing. Should you experience

such problems, you should relocate such wireless devices

so they are at a greater distance from this unit, or switch

them off.

355b

• When moved from one location to another where the

temperature and/or humidity is very different, water

droplets (condensation) may form inside the unit. Damage

or malfunction may result if you attempt to use the unit in

this condition. Therefore, before using the unit, you must

allow it to stand for several hours, until the condensation

has completely evaporated.

Maintenance

401a

• For everyday cleaning wipe the unit with a soft, dry cloth

or one that has been slightly dampened with water. To

remove stubborn dirt, use a cloth impregnated with a mild,

non-abrasive detergent. Afterwards, be sure to wipe the

unit thoroughly with a soft, dry cloth.

402

• Never use benzine, thinners, alcohol or solvents of any

kind, to avoid the possibility of discoloration and/or defor-

mation.

Repairs and Data

452

• Please be aware that all data contained in the unit’s

memory may be lost when the unit is sent for repairs.

Important data should always be written down on paper,

”Setting Memo.” During repairs, due care is taken to avoid

the loss of data. However, in certain cases (such as when

circuitry related to memory itself is out of order), we regret

that it may not be possible to restore the data, and Roland

assumes no liability concerning such loss of data.

Additional Precautions

551

• Please be aware that the contents of memory can be

irretrievably lost as a result of a malfunction, or the

improper operation of the unit. To protect yourself against

the risk of loosing important data, we recommend that you

periodically save a backup copy of important data you

have stored in the unit’s memory written down on paper,

”Setting Memo.”

552

• Unfortunately, it may be impossible to restore the contents

of data that was stored in the unit’s memory once it has

been lost. Roland Corporation assumes no liability

concerning such loss of data.

553

• Use a reasonable amount of care when using the unit’s

buttons, sliders, or other controls; and when using its jacks

and connectors. Rough handling can lead to malfunctions.

554

• Never strike or apply strong pressure to the display.

556

• When connecting / disconnecting all cables, grasp the

connector itself—never pull on the cable. This way you will

avoid causing shorts, or damage to the cable’s internal

elements.

558a

• To avoid disturbing your neighbors, try to keep the unit’s

volume at reasonable levels. You may prefer to use

headphones, so you do not need to be concerned about

those around you (especially when it is late at night).

559a

• When you need to transport the unit, package it in the box

(including padding) that it came in, if possible. Otherwise,

you will need to use equivalent packaging materials.

562

• Use a cable from Roland to make the connection. If using

some other make of connection cable, please note the

following precautions.

• Some connection cables contain resistors. Do not use

cables that incorporate resistors for connecting to this

unit. The use of such cables can cause the sound level to

be extremely low, or impossible to hear. For infor-

mation on cable specifications, contact the manufac-

turer of the cable.

AD-8_e.book 4 ページ２００７年６月２０日　水曜日　午前９時３４分

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Roland AD8 in the language / languages: English, German as an attachment in your email.

The manual is 3,92 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Roland AD8 Manual

Product: