168917
23
Zoom out
Zoom in
Previous page
1/32
Next page
23
2. INPUTS – OUTPUTS – CONTROLS
2.4 MODEL RN-460-200
1. RCA line inputs (CH5; left and right channels). Line
inputs for connection of the amp with RCA line-outs of
the head unit
2. RCA line inputs (CH3 + CH4; left and right channels).
Line inputs for connection of the amp with RCA line-outs
of the head unit
3. RCA line inputs (CH1 + CH2; left and right channels).
Line inputs for connection of the amp with RCA line-outs
of the head unit
4. RCA input operation mode slide switch. Used to
select 2CH / 4CH or 5CH inputs, to drive all five channels
of the amp
5. Input gain control. LEVEL adjustment for channel CH5.
Used to match the RCA line output voltage of the head
unit to the amplifier input section
6. Bass EQ control. Bass emphasis adjustment for CH5
with a center frequency of 45 Hz from 0 dB to 10 dB
7. Low pass crossover frequency control, to adjust the
cut-off frequency of the channel CH5
8. Remote port. To connect the cable of the bass level
remote control to the amplifier, controlling CH5
9. Molded terminal for the connection of speaker wires
CH1 & CH2, CH3 + CH4 and CH5 to the amp
10. Maxi fuse to protect the power supply of the amplifier
from damage
11. “+12V” for connection to the positive terminal of car
battery
12. “REM” for the automatic (remote) turn-on / turn-off of
the power amplifier from the head unit's amplifier remote
wire
13. “GND” for connection to chassis ground or negative
terminal of car battery
14. Input gain control. LEVEL adjustment for channels CH3
+ CH4. Used to match the RCA line output voltage of the
head unit to the amplifier input section
15. Low pass crossover frequency control, to adjust the
cut-off frequency of the channels CH3 + CH4
16. X-Over operation mode slide switch. Used to select
high pass, low pass/band pass or full range operation of
the active crossover for channels CH3 + CH4
17. High pass crossover frequency control, to adjust the
subsonic cut-in frequency of the channels CH3 + CH4
18. Input gain control. LEVEL adjustment for channels CH1
+ CH2. Used to match the RCA line output voltage of the
head unit to the amplifier input section
19. High pass crossover frequency control, to adjust the
subsonic cut-in frequency of the channels CH1 + CH2
20. X-Over operation mode slide switch. Used to select
high pass or full range operation of the active crossover
for channels CH1 + CH2
NC-Amp 1-2-4-5-CH Manual_D+E_pfade.indd 23 09.05.2009 11:25:33 Uhr
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rodek rn 1600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rodek rn 1600 in the language / languages: English, German as an attachment in your email.

The manual is 2,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info