167804
21
Zoom out
Zoom in
Previous page
1/32
Next page
21
9. Lowpass crossover frequency control, to adjust
the cut-off frequency of the channels CH3/4
10. Slide switch to activate/deactivate the phase-shift
control
11. Phase-shift control, to alter the acoustical phase
of the output signal
12. Operation LED, is lit blue when power is on
13. Protection LED, is lit red when the amplifier is shut
down because of malfunction, overheating or short-cut
on speaker cable leads
14. Terminal block for the speaker wire connection
15. Fuses
16. "+12V" for connection to the positive terminal of car
battery
17. "GND" for connection to chassis ground or negative
terminal of car battery
18. "REM" for the automatic (remote) turn-on / turn-off
of the power amplifier from the head-unit's remote or an-
tenna control lead
19. "REMOTE" LOW PASS LEVEL INPUT telephone
jack port for connection with dash-mounted low-pass
level remote unit
1. RCA inputs (CH1/2, CH3/4, left and right channels),
Line inputs for connection with RCA line-out’s of the
head-unit
2. Input gain control, LEVEL adjustment for channels
CH1/2. Used to match the RCA line output voltage of the
head-unit to the amplifier input section.
3. Operation mode selector, slide switch to select
Highpass, Bandpass or Fullrange operation of the active
crossover for channels CH1/2
4. Highpass crossover frequency control, to adjust
the cut-in frequency of the channels CH1/2
5. Lowpass crossover frequency control, to adjust
the cut-off frequency of the channels CH1/2
6. Input gain control, LEVEL adjustment for channels
CH3/4. Used to match the RCA line output voltage of the
head-unit to the amplifier input section.
7. Operation mode selector, slide switch to select
Highpass, Bandpass or Fullrange operation of the active
crossover for channels CH3/4
8. Highpass crossover frequency control, to adjust
the cut-in frequency of the channels CH3/4
1. INPUTS - OUTPUTS - CONTROLS
R1500-4100A2 Manual.indd 21R1500-4100A2 Manual.indd 21 07.07.2004 10:59:09 Uhr07.07.2004 10:59:09 Uhr
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rodek r 1500 a 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rodek r 1500 a 2 in the language / languages: English, German as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info