819495

Rocktrail TZ-10651 - IAN 388322 Manual

17
Zoom out
Zoom in
Previous page
1/84
Next page
17GB/IE
Use
WARNING! Precautionary
measures for fire and ventilation.
Precautionary measures for your
safety:
• Additional ventilation is required
when using gas or other combus-
tion devices.
• Do not place hot appliances near
the walls, roof or door flaps.
• Always follow the safety informa-
tion for these appliances.
• Never allow children to play near
hot appliances.
• Keep the entrance clear.
• Make sure you are aware of the
fire precautions on the premises.
• Make sure the ventilation openings
are open at all times to prevent
suffocation.
There is a plastic eyelet on the inside
of the tent roof where you can hang
a camping light (not included in the
package contents). The tent’s inner
pockets can be used for daily items
or clothing.
Opening door and window
Note: water condensation general-
ly occurs in all tents, but especially
when there are strong temperature
fluctuations. After a night in the tent,
there will be water condensation
drops on the inside surface. Conden-
sation is not a sign of leaks. Good
ventilation reduces condensation
inside the tent.
In order to open the tent entrance or
window:
1. Unzip the outer door and window
material.
2. Roll up the fabric lengthwise into
a roll.
3. Fasten it with the toggle to prevent
it from unrolling.
4. Unzip the inner door and window
material.
5. Roll up the fabric lengthwise into
a roll.
6. Fasten it with the toggle.
Note: the door of the outer tent can
be either half opened or completely
opened at the front. Use the loops
(2a) as shown in Fig. F.
Closing door and window
To completely close the tent en-
trance or window, proceed as
follows:
1. Unfasten the toggle.
2. Roll the fabric out.
3. Do up the zips.
Disassembly
Note: dismantle the tent in as dry
and clean a condition as possible,
to prevent mould formation and
stains. After dismantling in the rain,
let the product dry out completely
before packing it away. Clean all
components thoroughly before pack-
ing them away.
1. Remove all ground pegs (4)
(Fig. G).
2. Roll up the guy lines.
3. Remove the outer tent.
4. Pull the fibreglass poles (3) off the
pins of the metal rings (1a) and
fold them up.
5. Place the ground pegs (4) and
the fibreglass poles (3) in the
respective storage pouches (5)
and (6).
Folding pattern
1. Spread the inner tent (1) flat.
2. Fold the inner tent first lengthwise
to approx. one third of its width,
then once crosswise (Fig. H).
3. Lay the outer tent (2) folded in the
middle so that its sides lie on top
of each other.
4. Fold the outer tent once length-
wise, then twice crosswise as
shown in Fig. I.
Important! When folding, make
sure that the maximum folding
dimensions of the inner and outer
tent do not exceed the length of the
folded fibreglass poles.
5. Place the folded inner tent on top
of the folded outer tent.
6. Place the storage pouches (5)
and (6) on one end of the fold-
ed tents and roll all components
together tightly.
7. Tie the rolled product with the ties
and stow it in the carry bag (7).
Repairs, care and
storage
Repairs
Small tears or holes in the fabric can
be repaired with standard repair
patches.
Small leaks along the seams can be
remedied with a seam spray (not
included in the package contents).
A waterproofing spray can be used
on the tent surface.
Important! Do not use repair
patches on the seams.
Enquire at a specialist shop about
what repair materials to use and
how to use them. Follow the manu-
facturer’s instructions. Larger tears
should be repaired by someone with
technical skills.
Broken or defective frame parts
must immediately be replaced, and
must no longer be used. Enquire
at a specialist shop about suitable
replacement parts.
Zips
Note: zips are wearing parts and
are not covered by the warranty.
Regularly use a silicone spray (not
included in the package contents)
and apply it to the zips to prevent
unnecessary wear. Enquire at a spe-
cialist shop about a suitable silicone
spray and its use.
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rocktrail TZ-10651 - IAN 388322 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rocktrail TZ-10651 - IAN 388322 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 5.26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info