490248

Rockford Fosgate Punch P400-2 Manual

10
Zoom out
Zoom in
Previous page
1/52
Next page
10
SPECIFICATIONS
MODEL- Punch P200-2 P300-2 P400-2 P500-2
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Per Channel 50 Watts x 2 75 Watts x 2 100 Watts x 2 125 Watts x 2
2 Load Per Channel 100 Watts x 2 150 Watts x 2 200 Watts x 2 250 Watts x 2
4 Load Bridged 200 Watts x 1 300 Watts x 1 400 Watts x 1 500 Watts x 1
Dimensions: Height 2.25" (5.71cm) 2.25" (5.71cm) 2.25" (5.71cm) 2.25" (5.71cm)
Width 7.625" (19.37cm) 7.625" (19.37cm) 7.625" (19.37cm) 7.625" (19.37cm)
Length 9.0" (22.80cm) 9.0" (22.80cm) 10.25" (26.03cm) 13.02" (33.07cm)
Battery Fuse Rating (Amp) 40A 50A 80A 100A
External (Not Supplied)
“A” Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms ≥85 dB
“A” Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms ≥105 dB
Crossover Slope 12dB/octave Butterworth
Crossover Frequency variable from 50Hz to 500Hz
Frequency Response 20Hz to 20kHz ±1dB
Signal Voltage Adjustment Range Variable from 150mV to 5V (RCA Input)
Protection NOMAD - Internal analog-computer output protection circuitry
limits power in case of overload,plus short protection.
Thermal switch shuts down the amplifier in case of overheating.
Equalization PEQ (Punch Equalization) Variable from 0dB to +18dB @ 45Hz and/or
0dB to +12dB @ 12kHz
Input Impedance 20K ohms
Operating Voltage 9 to 16 Volts DC
Balanced Inputs Yes
CMRR (Common Mode Rejection Ratio) >55dB @ 1kHz
Damping Factor >200
THD+N (Total Harmonic Distortion + Noise) < 0.1 @ 2 ohm and < 0.05 @ 4 ohm
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice
2. Bypass any and all electrical components between the stereo and the amplifier(s).Connect stereo
directly to input of amplifier.If noise goes away the unit being bypassed is the cause of the noise.
OR
3. Remove existing ground wires for all electrical components.Reground wires to different locations.
Verify that grounding location is clean,shiny metal free of paint,rust etc.
OR
4. Add secondary ground cable from negative battery terminal to the chassis metal or engine block of
vehicle.
OR
5. Have alternator and battery load tested by your mechanic.Verify good working order of vehicle
electrical system including distributor,spark plugs,spark plug wires,voltage regulator etc.
TROUBLESHOOTING
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rockford Fosgate Punch P400-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rockford Fosgate Punch P400-2 in the language / languages: English, German, French, Italian, Spanish, Spanish as an attachment in your email.

The manual is 2,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info