644609
6
Zoom out
Zoom in
Previous page
1/22
Next page
Consumable parts
1. Blade
2. Virtual wire
3. Pegs
1
Handle:
2
Bumper:
To change a new direction when it
bump obstacles.
3
Charging point
4
Emergency switch:
Press it at any time, the mower
turn off at once.
5
Charging terminal:
Connect with charger for recharge
directly.
6
Rain sensors:
Mower goes back to charging
station automatically when it rains.
7
Power light
8
Key switch:
on
off
99
10
Blade
11
Safety hence:
To keep off foot and hands
12
Handle
13
Blade shed
14
Tyre cover:
Take it out and change the wheel.
15
Virtual wire light
Red: broken wire/idle
Colorless: good wire connecting
16
Charging light
Red: charging
Green: fully charged or idle
17
Charge terminal
18
Virtual wire terminal
Connect the virtual wire randomly.
there is no positive and negative.
19
Charging sheet
20
Guide channel
21
Stakes hole
22
Charger
Used for directing the mower to
charging station or for recharge
directly.
23
Virtual wire / 100m
Used to mark mowing area and
create a virtual wall for the mower.
24
Stakes / 4pcs
Used for fix the charging station to
ground.
25
Blades
Two blades pre-installed on the
mower and two extra.
2. PRESENTATION
-P8--P7-
27
26
Pegs / 100pcs
Used for fix the virtual wire to the
ground around the lawn perimeter
and around obstacles.
Remote control
Omni-directional wheel
28
Key / 2pcs
29
Remote control battery
30
English user maual
2. PRESENTATION
2.2 Functions
- Lift sensor
There are lift sensors located on each omni-directional wheel. If the
mower was lifted 2cm from the ground in level way, it will stop working
within 2 seconds.
- Tilt sensor
There is tilt sensor installed on the mower too, when the mower was
tilted over 30 degree at any direction, it also will stop working within 2
seconds.
- Bump sensors
In front of the mower there equipped with bump sensors that will activate
when the mower strikes solid, fixed object when that object is at least
6.5cm in vertical height from the supporting surface of the mower. When
the bump sensor is activated, the mower will stop movement in that
direction and reverse itself away from the obstacle.
- Rain sensors
There are two rain sensors on top cover of mower. The mower will go back
to the charging station automatically when it's raining.
- Wireless controller
To control the operate of mower in manual pattern.
- Anti-theft function
The mower should be turned on by key. And it cant start working without
a matched charging station.
- Virtual wire
The robot lawn mower can't operate without a virtual wire. (we suggest to
use 100m-300m of virtual wire). It leads the mower back to charging
station and the mower will take it as a wall when it is operating. It will gets
on the virtual wire until it meets charging sheet which located in front of
charging station, then it gets off virtual wire and starts cutting
- Cutting height selection
There are two choice, 3cm and 4cm.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robot Mower TC-G158 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robot Mower TC-G158 in the language / languages: English as an attachment in your email.

The manual is 5,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info