512484

Robomow Tuscania 500 Manual

66
Zoom out
Zoom in
Previous page
1/268
Next page
EN
12
Note: The power supply is suitable for outdoor use, yet it is required placing it in a sheltered
place, dry location, which is well ventilated and not exposed to direct sunlight.
Place the Base Station at least one-meter from corners;
Position the Base Station with its fence facing to the inside of the lawn;
Robomow is impervious to water and rain, however it is recommended to place the Base Station
away from sprinkler heads for maximum protection.
1.2.2 Multiple Zones/Areas
Your home may require more than one zone to be set up in order for the Robomow to work in all of your lawn
effectively. Where grass areas are not contiguous, or are separated by fences, sidewalks or other objects, it is
required to make each of these a separate zone.
When setting separated zones there are two options to lay the wire:
Option A
: All zones are looped together and connected to the Base Station. If the distance between two adjacent
wires is greater than one meter, you can include it in the main loop connected to the Base Station as Robomow
can effectively navigate through in order to move between the two areas while mowing the lawn, otherwise it is
required to separate the area into two different zones.
Perimeter wire can be as long as 500 meters (1650ft) in one loop when connected to the Base Station (Figure 1.4).
Option B
: There are separated zones (Figure 1.5) that connected to the Base Station and the Perimeter Switch
(available as an accessory- see Chapter 7).
To mow other areas, simply drive or carry Robomow to the area you want to mow and operate it. In this way, if
one zone needs a shorter operating time than another, it can easily be set (Chapter 2.1.2). When this area is
completed, drive the mower back to the station for re-charging.
Determining the distance between adjacent perimeter wires:
1. If lawns are installed by the same perimeter wire that is connected to the same source (Base Station /
Perimeter Switch), then it is enough to keep a distance of one meter between the wires to prevent
interference in operation.
2. If lawns are installed using different perimeter wires that are not connected, and each has its own source
(Base Station / Perimeter Switch), then one of the following is required:
a. Maintain a minimum distance between the wires (30-50cm) to allow overlap between mowing zones,
but synchronize between the mowing schedules to confirm there will not be interference between the
zones. OR
b. Keep two meters between the perimeter wires with no need to synchronize between the operation
schedules.
WARNING!
Serious Injury Can Occur! When placing the power cord
leading to the Base Station, insure it is fastened securely to
the ground and does not present a tripping hazard.
Do not cross over surfaces such as sidewalks and
driveways where it cannot be fastened securely.
Figure 1.3 -
Base Station distance from wall socket
The Fence
should be
inside lawn
Min 1m (3ft)
from a corner
Max 15m (50ft)
Low voltage
cable
… 66 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow Tuscania 500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow Tuscania 500 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 9,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info