537223
40
Zoom out
Zoom in
Previous page
1/50
Next page
40
9.3 User Messages
The next table gives information about User Messages that can be displayed on the mower:
Display Message Probable Cause/Event Correcve Acons
0021
Check
mowing height
- Mowing motor has faced over-current
conditions for too long as a result of
high grass or an obstacle that is stuck or
wrapped around the blade.
- Something is preventing a blade from
rotating freely.
- Severe grass accumulation under the
mowing deck, rope, or similar object is
wrapped around mowing blade.
- CAUTION – Switch Off the Safety Switch
before checking the blade.
- Inspect the blade for foreign material or
debris preventing rotation.
- Clean out accumulated grass clippings
using a wooden stick.
0022
Check
mowing motor
- Mowing motor has faced over-current for
too long in the Base Station before starting
the operation.
- CAUTION – Switch Off the Safety Switch
before checking the blade.
- Remove the mower from the Base Station.
Inspect the blade for foreign material or
debris preventing rotation.
0023
Check power - See E4 in the above table
0026
Base problem
- Robomow fails to enter the Base Station
several consecutive times.
- Adjust the Base Station position.
- Clean the contacts with a brush or piece of
cloth.
0027
Start
Elsewhere
- Drive wheel motors have been working
under severe load during automatic or
manual operation.
- Check to insure the mower is not stuck,
causing the drive wheels to slip.
- Check the ground around the mower for
holes or indentations. Fill with dirt and level
off.
- Check if the drive wheels are free to rotate
and nothing is blocking them.
- Remove the mower away from this
particular location and restart operation.
0028
Cross Outside
- The Perimeter Wire is too close to the
edge.
- The lawn slope is too big.
- Robomow does not succeed to turn in
place at the edge and it causes the mower
to slip out of the designated area.
- Robomow has slipped out of the Perimeter
Wire lope because of sloping area or wet
grass.
- Remove the wire towards the inner part of
the lawn.
- Do not include this area because of its
steep slopes.
- Fill holes and pits in the ground.
- Increase the cutting height.
0030
Start Inside
- Automatic operation is initiated while the
robot is placed out of the Perimeter Wire
loop.
- Place the mower inside the lawn and renew
the operation.
0031
Stuck in place - See E1 in the above table
0060
Check
Intensity
- The Intensity you have set is too high for
your lawn area.
- Decrease the Intensity you have set for the
zone(s) in your lawn.
0061
Decrease
Inactive Time
- See E8 in the above table
Display Message / Descripon Acon Required
BATT
Recharge Battery. Low battery voltage. Recharge the Battery.
U001
Test Base Station position.
Displayed during the One-Time Setup.
Refer to section 5.2.4 in the User Manual.
U002
Peg Base Station.
Displayed during the One-Time Setup.
Refer to section 5.2.4 in the User Manual.
U003
Test wire position.
Displayed during the One-Time Setup.
Refer to section 5.2.5 in the User Manual
U004
Test wire ended (during the One-Time Setup)
Displayed only when using the Robomow App.
No action is required.
U018
Operation time is shorter than expected Battery run time is too short. Replace Battery.
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow TC500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow TC500 in the language / languages: English as an attachment in your email.

The manual is 3,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow TC500

Robomow TC500 User Manual - German - 50 pages

Robomow TC500 User Manual - Dutch - 50 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info