537227
23
Zoom out
Zoom in
Previous page
1/54
Next page
13
Initial Setup
EN
Peg the two Perimeter Wires down to the ground using the
same peg leaving enough loose wire.
Twist together the two loose parts.
Insert the end of the wire without the connector into the hole of the other
wire’s connector. Use a small flat screwdriver to tighten and secure this
wire into the connector.
2.6 Assembling the Base Station
2.6.1 Laying and fastening power cord
-
Safety – Avoid injury!
The Extension Cable should be securely fastened to the ground!
It should never present a tripping hazard.
The power cord should cross over soft surfaces ONLY. It should not cross
over hard surfaces (e.g. sidewalk, driveway) where it cannot be securely
fastened.
2.6.2 Base Station Assembly
2.6.3 Base Station Head and Base:
Remove the Base Station Head from the Base.
Electric Shock Hazard!
Disconnect the Power Box from the plug socket before any approach to the Base
Station charging contacts (pins).
Pull the lever (A) upward
Push the Base Station head from the front side in the
direction marked B.
The head will slide out.
Stakes x 6
Base
Base Station Head
(Charging Adaptor)
Small flat screwdriver
Flippers x 2
A-Pull
B-Push
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow RS612 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RS612 in the language / languages: English as an attachment in your email.

The manual is 7,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RS612

Robomow RS612 User Manual - German - 54 pages

Robomow RS612 User Manual - Dutch - 54 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info