512472
20
Zoom out
Zoom in
Previous page
1/60
Next page
20
1.4.5 Placing and Connecting the Base Station
Connect the Perimeter Wire connector to the Base
Station board (Figure 1.19).
Before securing the Power Supply cord to the Base
Station, carefully lay the length of the cord out,
beginning from the Base Station and leading to the
main power supply and insure it is fastened securely to
the ground and does not present a tripping hazard.
Do not cross it over surfaces where it cannot be
fastened, such as sidewalks or driveways. For ultimate
protection, consider an underground placement within a
protective conduit.
Connect the Power Supply cord to the Base Station
board. See Figure 1.20.
Route the Power Supply cord into the Base Station
cover as shown in Figure 1.21.
Close the cover of the Base Station; confirm it is locked
well in its place (Figure 1.22).
Align the Base Station on the Perimeter Wire, so the wire is aligned with the two central lines
marked at the front and rear side of the Base Station, as shown in Figure 1.23. Do not fasten the
Base Station yet, as you will want to check its final position first.
Connect the power supply to a regular household receptacle 230 Volts AC.
A small flashing green light in the Base Station cover indicates the system is on and functioning
properly. Continuous beeps indicate a disconnected/broken perimeter wire. Discontinuous beeps
indicate poor splicing of perimeter wires or perimeter wire, which is too long (the max allowed in
one loop is 500 meters).
Figure 1.21 -
Routing the Power Supply
cord out of the cover
Figure 1.22 -
Closing the Base Station cover
Figure 1.23 -
Base Station alignment
Figure 1.19 -
Perimeter Wire connection
to the Base Station
Figure 1.20 -
Power Supply cord connection
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow RM510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RM510 in the language / languages: English as an attachment in your email.

The manual is 3,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RM510

Robomow RM510 User Manual - German - 60 pages

Robomow RM510 User Manual - Dutch - 60 pages

Robomow RM510 User Manual - French - 61 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info