Manual Robomow RC308 Pro (page 23 of 58) (English)

664048

Zoom out

Zoom in

1/58

4.3.4 Using Sub-Zones as Remote Starting Points

There are cases when a Main Zone has two or more big parts connected by a wide (more than 2 meters) passage,

like a front and a back yards.

In order to ensure proper coverage of all Main Zone’s parts in such cases, you may want the mower to occasionally

startmowingatsomespecicpoint(otherthantheBaseStation)alongtheperimeterwire.Wecallthesepoints

–RemoteStartingPoints.SettingaRemoteStartingPointcanbedonebydening(adding)aSub-Zoneatthe

desired place (see section 6.4.2, P022-P023).

Note:

DuringtheSub-Zonedenitionprocessyouareaskedtospecifytheareaofanewlyaddedsub-zone.Incaseof

a Remote Starting Point, this area should be the area of the remote part of the Main Zone. You need to reduce

MainZone’sareasettingaccordingly(seesection6.4.1).Seetheexamplebelow.Thisprocessactuallydenes

the probability (or the frequency) of departures from each starting point (when for the Main Zone the Base Station

itself is a starting point).

Example:

Let’s say your Main Zone is 1000m

. It

has a back yard (400m2), where the

Base Station is installed, and a front yard

(600m2). In order to dene a Remote

Starting point for the front yard, start a

process of adding a Sub-Zone. Once

well inside the front yard, set the area of

the newly added Sub-Zone to 600 and

immediately reduce (see section 6.4.1)

the area of the Main Zone to 400m2.

Thus, we now have 40% probability for

the mower to start from the Base Station

to cover the back yard, 60% probability

to start from the Remote Starting point in

favor of the front yard, as demonstrated

in the following drawing:

4.4 Fastening Perimeter Wire to the

Ground

o Before starting to lay the Perimeter Wire, it is recommended to cut the grass where the wire is to be laid.

It will then be easier to attach the wire to the ground. The risk that the mower will damage the wire during

the operation is reduced.

o It is not necessary to bury the Perimeter Wire, though you may do so, up to 5 cm (2 inches) deep.

o Pull the wire tight while hammering the peg all the way into the ground.

o Considerburyingthewireatexposedareas,suchaspavementsorotherareaswithafrequentfoottrafc.

WARNING !

Protect your eyes! Protect your hands!

Use proper eye protection and wear appropriate work gloves when hammering the pegs.

Hard or dry ground may cause pegs to break when driving them in.

o Use a hammer to insert the pegs into the ground.

o Insert the pegs at distances that will keep the wire

down below the grass level and prevent the wire from

becoming a tripping hazard (approximately 75 cm /

30” between pegs).

• The wire and the pegs will gradually become

invisible under the growth of new grass.

Remote Starting Point

Main Zone

At least 2 meters (6.5 ft.)

wide

I have used my mower twice on manual recently with no problems. However I have set it up for Automatic and it is reading PAUS. In the manual it advises me to use the Automatic Operation On/of on my remote control, however I was never supplied with a remote control. Could you advise me how to override the PAUS button on my mower display panel. As I have been unable to contact your agent at present, I would appreciate your help. Thank you. Hedley Best. Submitted on 18-4-2020 at 15:33
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RC308 Pro in the language / languages: English as an attachment in your email.

The manual is 3,43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RC308 Pro

Robomow RC308 Pro Quick start guide - English - 4 pages

Robomow RC308 Pro User Manual - German - 58 pages

Robomow RC308 Pro User Manual - Dutch - 58 pages

Robomow RC308 Pro User Manual - French - 58 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Robomow RC308 Pro Manual

Product: