537218
21
Zoom out
Zoom in
Previous page
1/50
Next page
21
If the Narrow Pass is wider than 2m, and you want Robomow to mow the area inside the Narrow Pass, then you
can set the wire as shown in the gure below. Such a setup allows the mower to mow inside the Narrow Pass while
mowing the inner part of the lawn, but prevents it from crossing between the zones.
Sub-Zone
Main-Zone
10cm
30 cm
Perimeter
Island
As long as needed
when keeping 10cm
from both sides
4.4 Fastening Perimeter Wire to the
Ground
o Before starting to lay the Perimeter Wire, it is recommended to cut the grass where the wire is to be laid.
It will then be easier to attach the wire to the ground. The risk that the mower will damage the wire during
the operation is reduced.
o It is not necessary to bury the Perimeter Wire, though you may do so, up to 5 cm (2 inches) deep.
o Pull the wire tight while hammering the peg all the way into the ground.
WARNING !
Protect your eyes! Protect your hands!
Use proper eye protection and wear appropriate work gloves when hammering the pegs.
Hard or dry ground may cause pegs to break when driving them in.
o Use a hammer to insert the pegs into the ground.
o Insert the pegs at distances that will keep the wire
down below the grass level and prevent the wire from
becoming a tripping hazard (approximately 75 cm
between pegs).
• The wire and the pegs will gradually become
invisible under the growth of new grass.
o If an additional wire is required in order to complete
the setup, connect it using the water-proof wire
connectors supplied with Robomow. (See Section
11.4 – Splicing the Perimeter Wire).
A. At the point you want the mower
to
start driving towards the Sub-Zone
start to set the Narrow Pass.
B. Set an Island at the middle of the
Narrow Pass and keep a distance
of 10 cm (4 inches) from the
Perimeter Wire.
C. The island dimensions should be
30 cm along the side and as wide
as needed, keeping 10 cm from
both sides.
D. After completing the setup of the
wire in the Sub-Zone, make sure
you keep 10 cm (4 inches)
between the wire and the island
on the way back to the Main Zone.
Sub-Zone
Perimeter
Island
As long as needed
when keeping 10cm
from both sides
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow RC302 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow RC302 in the language / languages: English as an attachment in your email.

The manual is 3,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow RC302

Robomow RC302 Quick start guide - English - 4 pages

Robomow RC302 User Manual - German - 50 pages

Robomow RC302 User Manual - Dutch - 50 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info