644646

Robomow MS2500 Manual

20
Zoom out
Zoom in
Previous page
1/62
Next page
9
Initial Setup
P There should be a distance between the Island Wire and the Perimeter
Wire:
) Maintain a minimum of 1.5 m (5 ft.) between the Island wire and
the Perimeter Wire.
) Maintain a minimum of 1.5 m (5 ft.) between wires of adjacent
islands.
CAUTION: Setting the Perimeter Wire Anti Clockwise around the
obstacle will cause mower to drive into the island.
P Complete bordering the island and return to the spot where you left the
lawn’s edge.
P The wires leading to the Island and from it should be parallel and
touching.
Therefore, peg both wires, to and from the island, together with the
same pegs.
Robomow will not recognize these two wires.
It will mow over them as if they do not exist.
Robomow will recognize the single perimeter wire around the
Perimeter Island and will not enter this area.
P The minimum diameter of an Island should be 90 cm (3 ft.).
) If protected objects are grouped closely together, demarcate them
by a single, continuous, Perimeter Island.
) The minimum distance of the Perimeter Wire from the protected
area should be 32 cm (1 ft.).
Therefore, If protected objects are too close to the edge, leave
them out of the mowing area.
) A Perimeter Island should either be rectangular or round.
2.2.2 Setting a Narrow Pass
A Narrow Pass is a path that connects two zones of the lawn. The path
enables Robomow to drive between the zones while following the wire, but
prevents the mower from crossing between them while mowing the inner
area of each zone.
The pass must be at least 1.2 m (4 ft.) wide to allow Robomow to drive
through it.
If the pass is wider than 2 m (6.5 ft.) – there is NO need for any special
Perimeter Wire setting. Just include both the pass and the Sub-Zone in the
area covered by the Perimeter Wire.
Otherwise, follow the instructions below in order to set up a Narrow Pass.
EN
Perimeter Island – Min. 90 cm (3 ft.).
32 cm (1 ft.)
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robomow MS2500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robomow MS2500 in the language / languages: English as an attachment in your email.

The manual is 16,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robomow MS2500

Robomow MS2500 User Manual - German - 62 pages

Robomow MS2500 User Manual - Dutch - 64 pages

Robomow MS2500 User Manual - French - 62 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info