490298
16
Zoom out
Zoom in
Previous page
1/22
Next page
16
GB
INSTALLATION
Wall drilling and bracket fixing
Wall marking:
Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of
the area in which the hood will be installed.
Draw a horizontal line at 650 mm above the hob for installation without the back panel, or at height
H (height of the visible part of the panel) for installation with the back panel.
Place bracket 7.2.1 on the wall as shown about 1-2 mm from the ceiling or upper limit, aligning the
centre (notch) with the vertical reference line.
Mark the wall at the centres of the holes in the bracket.
Place bracket 7.2.1 on the wall as shown at X mm below the first bracket (X = height of the upper
chimney section supplied), aligning the centre (notch) with the vertical line.
Mark the wall at the centres of the holes in the bracket.
Place bracket 7.1 as shown 110 mm from the vertical reference line and 180 mm above the horizontal
reference line.
Mark the centres of the holes in the bracket.
Repeat this operation on the other side.
REAR PANEL (OPTIONAL)
The Rear Panel must be fitted before fixing the hood body and, if it is to be fixed at both top and bottom,
must be fitted at the correct height prior to installing the bases. As this operation is rather complex, it
should be carried out either by the kitchen installer or a qualified person who knows the final dimensions
of the units.
For fixing at the top only, proceed as follows:
Rest the back panel on the base, inserting the lower plate between the upper surface and the wall,
centring it on the vertical reference line.
Mark the centres of the two holes in the upper plate.
H 180
X
1÷2
650 min.
7.2.1
7.1
110
110
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Roblin Diva S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Roblin Diva S in the language / languages: English, French as an attachment in your email.

The manual is 0,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info