625577
26
Zoom out
Zoom in
Previous page
1/70
Next page
Z3200 10-V0713 25
English Deutsch
Option A5218:
Digital Flip stop on the cross-cut fence
For all the machines of the series Z and NZ, the digital ip stop, an absolute measurement system for
the cross cut fence, is optional. For more information about the settings of the 90° inclination according
to the main saw blade, see Adapting the cross cut fence
Placing the magnetic strip
atteNtioN:
The magnetic strips of the Z-series are shorter than the magnetic strips of the NZ-series.
When placing the magnetic strip, we recommend to remove the difference, after placing the magnetic
strip correctly.
The digital read-out system is placed into the guiding rail on the cross cut fence. It is very important to
check, before changing the setting of the system, that the active mode of the system is Abs and not
Incr. To change the mode of the system press the button Incr/Abs.
Calibrating the system: Place the 300 mm long piece Z1253 against the cross cut fence reaching
exactly one saw-tooth of the main saw blade. Push the ip over stop against the former mentioned 300
mm long element Z1253. Press, at the same time, the buttons <<F>>+<<Set>>. Doing this you will see
that 300.0 appears at the display. The system is calibrated. Using the button Incr/Abs you can create a
new zero point.
When lifting up the ipper so it looses contact with the magnetic strip, the setting are saved, so it will
be unnecessary to calibrate the system each and every time again after lifting of the ipper and loss of
contact with the magnetic strip.
When not using the system, it will automatically shut down after a time period of 20 minutes. To activate
the system again, just press one of the buttons.
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland Z3200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland Z3200 in the language / languages: English, German as an attachment in your email.

The manual is 3,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland Z3200

Robland Z3200 User Manual - Dutch, French - 66 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info