Manual Robland SD410 (page 50 of 98) (English, German, Dutch, French)

625583

Zoom out

Zoom in

1/98

SD410 - S410 V0114 49

NederlandsFrançaisEnglishDeutsch

Adjustment of the planer tables (Fig.5)

Fig.5

Both planer tables are set at the factory and do not require

readjustment.

When starting up the machine, and after changing the knives, the

output table should be perfectly aligned with the knives. To ensure

this, there is a handy little tool that you can make yourself : take

a square planed hardwood bar of about 30 cm in length and put

10 marks at 1 mm interval ( see drawing). Put one planer knive at

its highest point and put your scale with the “0” on the planer knife

top. Now turn the planer arbor one turn by hand and if the scale is

moved fot not more than 2 marks, the knives are well set.

Adjusting the outfeed table to the height of the knives is doen by

loosening the locking bolt and moving the table with the lever.

Retighten the locking bolt afterwards.

Planer fence (Fig.6)

The planer guide can be adjusted to the width of the workpiece by loosening the handle (1).

After unlocking the handle (2) and pushing the lever (3), the fence can be set at any desired angle

between 90 ° and 45 °.The desired angle can be read at the scale (4).

After setting the desired angle one needs to tighten the clamping lever (2) rmly.

The 45° stop bolt is at the bottom of the support, the 90° stop bolt at the top

planer guide support.

Fig.6

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Robland SD410 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,06 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Robland SD410 Manual

Product: