625583

Robland SD410 Manual

47
Zoom out
Zoom in
Previous page
1/98
Next page
46 V0114 SD410 - S410
Nederlands Français English Deutsch
Transportation of the machine
Depending on the method of transportation or shipping, you will receive the machine in a crate or on
transport blocks..
Always check if the payload of your hoist is sufficiently large. Lift the machine a few inches up and take
the bars or the bottom of the coffin away.
Make sure not to damage the frame when lifting the machine, put some cloth between the hoisting
band and the frame.
After unpacking, check that the machine for damages occurred during transport or during unloading.
Place the machine on a concrete base and level the machine horizontally in both directions.
Electrical connections (Fig.1)
The electrical connections must be carried out by a qualied electrician.
Make sure that the mains voltage of the machine corresponds with the voltage of your workshop.
Open the junction box (g.1) located on the frame below the entrance table and enter the connection
through the cable clamp.
Connect the three phases to terminals marked L1, L2, L3.
If the cable is equipped with a neutral ( blue) then it is connected to terminal N.
Always provide proper grounding and connect it to the terminal marked with the symbol of the earth
(the earth conductor green-yellow).
Check the rotation direction of the arbor. If it is wrong, the leads L1 and L2 must be exchanged.
The motors are protected against overload. When the engine is turned off by that security, you must
wait until the engine has cooled down before restarting the machine.
Fig.1
… 47 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland SD410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland SD410 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 4,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info