625579

Robland NZ Axis Ergo Manual

21
Zoom out
Zoom in
Previous page
1/82
Next page
– English – Deutsch
20 V1110 NZ3200 - AXIS ERGO
RPM indicator lights (Fig.29)
After the machine has been switched on by the main switch, the indicator lights at the front electrical
panel show the speed of the saw arbor. When changing speed always take care that the indicator
detector (1) is placed in the correct position, to avoid the belt rubbing against the detector, leading to a
premature wear of the belt.
This can be felt and seen.
The machine has 3 RPMs : 3000 - 4000 - 5000.
Belt tension and speed changing (Fig.28)
1 Main sawbelt:
Always choose the speed according to the sawblade diameter and never exceed the maximum
allowed cutting speed for carbide tipped sawblades of 100 m/sec.
This is a very important safety rule.
To loosen the belt, pull and turn handle (1) to the left. When the belt has been changed or put in
another groove of the pulleys and the indicator detector (2) has been checked for its correct position,
the belt has to be tensioned. Pull and turn the handle (1) to the right and engage it into the serrated
span sector. (3)
Make sure the belt is not overtensioned, because this leads to damage of the saw arbor and belt.
Check regularly the condition of the belt and, if necessary, replace it (partnr. N8207 : XPA 800
Quadpower).
2 Scoring sawbelt:
To tension the scoring sawbelt loosen the two nuts (1-2) which hold the motor, push the
motor down, tighten the two nuts while holding the motor down.
To change the belt remove the motor completely. When the belt is replaced, but before
tensioning it, ensure that it is correctly seated into the grooves of both pulleys.
Fig.28
Fig.30
Fig.29
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland NZ Axis Ergo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland NZ Axis Ergo in the language / languages: English, German as an attachment in your email.

The manual is 6,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland NZ Axis Ergo

Robland NZ Axis Ergo User Manual - Dutch, French - 86 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info