Manual Robland NZ Axis Ergo (page 18 of 82) (English, German)

625579

Zoom out

Zoom in

1/82

– English – Deutsch

NZ3200 - AXIS ERGO V1110 17

Mitre fence (Fig.23)

The at T-nut which holds the vertical rod of the wood clamp is factory set and has to stay in its position

to make the angle scale correspond.

To set the required angle : unlock the rod (1) and the auto-release handle (2). To slide the

fence (5) towards the sawblade, unlock the two handles (3). Reading the angle set is done at the back

of the aluminum bracket (4).

Use of the parallel fence (Fig.24)

When the serrated knob (3) is unlocked and the handle (1) is lifted up, the complete parallel fence can

be moved.

To lock the fence in position push the handle (1) down.

The micrometric adjustment is achieved by locking the knob (3), by holding the handle (1) in the

upright position and by turning the serrated knob (2).

After the adjustment, push handle (1) down to lock the fence in place. When cutting small workpieces

with the sawunit inclined at 45°, the fence should be used in the low position.

Simply unlock the eccentric clamping handle (4), slide off the fence and slide it back on in the low

position.

Lock the fence with the eccentric clamping handle (4).

When cutting solid wood using the parallel fence, to avoid the wood getting stuck between the fence

and the riving knife (resulting in a hightly dangerous kickback) it is recommended to

reposition the fence so that its end protrudes just past the end of the riving knife.

Fig.23 Fig.24

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Robland NZ Axis Ergo in the language / languages: English, German as an attachment in your email.

The manual is 6,34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland NZ Axis Ergo

Robland NZ Axis Ergo User Manual - Dutch, French - 86 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Robland NZ Axis Ergo Manual

Product: