Manual Robland NZ Axis Ergo (page 17 of 82) (English, German)

625579

Zoom out

Zoom in

1/82

– English – Deutsch

16 V1110 NZ3200 - AXIS ERGO

Adjusting the cross-cut fence (Fig.19-20-21)

Each and every time changing a blade with different specications it is vital to calibrate the scale of the

length supported guide according the following application. Block the knob (1) with the 300 mm piece

and adapt the graduated scale till obtaining 300 mm in the lens.(g. 19,2) Continue the same way with

the digital stop option, pressing << SET >> and the stop will be automatically adjusted. Test the setting,

making a little cut just to verify. For the work with the telescopic extension of the guide (permitting to cut

at approximately 3000 mm), place the knob (g. 20-21,3) on the exact measurement of 2050 mm, so

that the scales corresponds on the two different parts. The reading can be done on the index (g. 20,4),

on the xed part of the length supported guide. To verify if the effective measurements correspond to

the regular dimensions mentioned in the index; continue with a test, placing the two knobs at a certain

dimension and check if the maintained measurements correspond with the ones of the index.

When, after some time, the wooden splitter protection cap at the front on the cross-cut fence is cut

away, a new one has to be made according diagram g. 22

Fig.19

Fig.21 Fig.22

Fig.20

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Robland NZ Axis Ergo in the language / languages: English, German as an attachment in your email.

The manual is 6,34 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland NZ Axis Ergo

Robland NZ Axis Ergo User Manual - Dutch, French - 86 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Robland NZ Axis Ergo Manual

Product: