625559
38
Zoom out
Zoom in
Previous page
1/46
Next page
NX SERIES V0913 37
English
Fig.29
Thicknesser adjustment (g. 30)
1 The rise and fall of the thicknesser table can be adjusted with the handwheel (1). One turn of this
hand wheel equals 4 mm.
2 After height setting the thicknesser table has to be locked with the lever (2) situated behind the
hand wheel, the height of the table can be read at the scale (3).
3 When, after intensive use of the locking lever (2), it is no longer possible to lock it, take off the nut
which holds the lever and remove the lever. Then turn the lever 1/6 turn clockwise and put it back
on again. Put the nut back on and tighten it again.
4 The table height cutting depth setting has to be adjusted in such a way that there is always 1 mm
minimum clearance between the top of the wood and the connection bar between the bearing
houses.
5 Always ensure that the anti-kickback protection fingers are kept clean and hang down freely in
position under their own height.
6 The feeding mechanism can be engaged by unlocking the lever (4) and pulling it up. The feed
through speed is 7 m/min.
7 In case of overloading of the feeding mechanism the feed rollers must be disengaged
immediately by pushing down lever (4). Most likely the cutting depth setting is too big. Lower the
table ½ a turn with the hand wheel and start all over again.
Important
A smooth table surface is essential for good operation of the thicknesser. Therefore the table should be
cleaned and rubbed in with normal cheap whit paraffin wax regularly. A roller support should be used
when long work pieces have to be machined.
Fig.30
4
1
2
3
1
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland NXTZ at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland NXTZ in the language / languages: English as an attachment in your email.

The manual is 1,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland NXTZ

Robland NXTZ User Manual - German - 100 pages

Robland NXTZ User Manual - Dutch - 100 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info