625558
42
Zoom out
Zoom in
Previous page
1/46
Next page
NX SERIES V0913 41
English
Fig.37
The drive chain for the feeding system on the thicknesser can very easily be lubricated by opening the
planer in feed table. Now the drive chain can be seen right next to the planer table locking bolt. The
little cover plate X0164 can be removed by removing the table locking bolt. When however the chain
has to be replaced, then the complete saw spindle table has to be taken off to reach this chain.
Problems
Troubleshooting causes and solutions Oorzaken en oplossingen
1 The machine does not start when the start switch is activated:
main switch off;
power supply failure;
emergency stop button activated;
main fuse blown;
overload activated due to motor overload;
fault in the electrical system or machine connection;
planer tables opened and dust chute thicknesser not in position.
2 Reduction of speed when working:
belt tension not correct;
motor overload due to incorrect feed speed;
blunt tools.
3 Vibration of the tools mounted on the spindles:
the tool is unbalanced; replace or have the balancing done by specialised personal and equipment.
4 Thermal overload does not re-arm automatically after shut-off and cooling down period:
overload is not set for automatic reset or have the overload is faulty
Adjusting the spindle motor brake
When after extended use of the spindle, the brake down time of the motor exceeds10 seconds the
brake will need to be re-adjusted.
Without removing the motor cowling, put a 5 mm Allen key into the countersunk bolt and turn the bolt
until the air gap between brake and ventilator fan is 0,2 mm.
Make a test run with the motor and check if the brake time is about 8 to 10 seconds.
belt spanner handle
7500
6000
4000
2900
2900 T/Min.
Speed indicator
Put the fork according
the chosen speed
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland NX410 Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland NX410 Pro in the language / languages: English as an attachment in your email.

The manual is 1,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland NX410 Pro

Robland NX410 Pro User Manual - German - 100 pages

Robland NX410 Pro User Manual - Dutch - 100 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info