625546
23
Zoom out
Zoom in
Previous page
1/98
Next page
22 V0212 HX SERIES
English
Deutsch
Use of the cross-cut fence (g. 15)
The measuring tape of the cross-cut fence is factory set. To make sure the measurements correspond
to the index, do the test where you place the 2 ip-stops on a certain distance and check if the
obtained distances are the same as the distances of the index.
Lock the ipper at a dened length and cut off a sample.
Now take the exact measurements of the sample.
To calibrate the index, remove the 2 handles of the fence on the table, without removing the fence from
the outrigger table. Inside the 2 locating pins of the fence you will nd a socket cap screw.
Loosen the two socket caps, which enable you to move the fence to equalize the measurements with
the index.
Tighten the two socket cap screws again and place the 2 locking handles. To calibrate the index on the
telescopic part, loosen the 2 socket caps holding the short part of the fence on the square telescopic
tube. Now repeat above in order to calibrate the scale on the telescopic part of the fence.
Tighten the two socket cap screws again.
Fig.15
Drawing of the splinter protection (g. 16)
The fence is equipped with a splinter protection. When the splinter protection is damaged, it should be
replaced. It can be replaced by a piece of wood that has the following dimensions:
Fig.16
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland HX310 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland HX310 in the language / languages: English, German as an attachment in your email.

The manual is 5,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland HX310

Robland HX310 User Manual - Dutch - 48 pages

Robland HX310 User Manual - Dutch, French - 102 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info