Manual Robland HX260 (page 24 of 98) (English, German)

625545

Zoom out

Zoom in

1/98

HX SERIES V0212 23

– English – Deutsch

Mitre fence (g. 17)

The mitre fence is mounted on to the sliding table as shown on the picture. The at nut in the groove of

the table is factory set at 90°.

For tilting the mitre fence, loosen the vertical post (1) of the wood clamp and the Kipp handle (3) and

move the fence to the wanted angle.

The reading is done at the back of the support plate of the guide itself. Loosen both Kipp handles (2)

for moving the fence as close as possible to the saw blade.

Make sure that all handles are fastened after the adjustment of the fence.

To remove the fence from the table: loosen the vertical post (1) of the wood clamp and the Kipp handle

(3) and remove it.

Fig.17

Spindle

Mounting the tools on the spindle (fig.18)

1 Set the brake release switch of the selector switch on in order to free the brake and turn the

spindle free by hand and set the Allen key on the countersunk Allen bolt on top of the spindle

arbor (1)

2 Push the locking lever (2) to the right and, at the same time, manually turn the spindle arbor (3)

until the lower locking pin locks into the hole in the spindle.

3 Now loosen the clamp screw on top of the arbor with the Allen Key.

4 Always mount the spindle as low as possible on the arbor, so the bearing isn’t overloaded.

5 Mount the correct number of spindle rings and tighten the screw, on top of the arbor.

6 When the lever (2) is released, the locking of the spindle arbour is automatically disengaged.

7 Always lock the position of the spindle height by locking the handle (3) behind the handwheel.

Fig.18

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Robland HX260 in the language / languages: English, German as an attachment in your email.

The manual is 5,13 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland HX260

Robland HX260 User Manual - Dutch, French - 102 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Robland HX260 Manual

Product: