625545
18
Zoom out
Zoom in
Previous page
1/98
Next page
HX SERIES V0212 17
English Deutsch
Mounting of the saw blade (g.7)
1 Slide away the table.
2 Open the lower saw blade cover plate (1).
3 Raise the saw blade to the highest point.
4 Now put the locating pin (3) in the saw table to block the saw arbor.
5 Tighten the saw nut with the hookspanner (4). Warning: left hand threaded saw arbor!
6 Do not forget to remove the pin which holds the saw arbor in place while tightening the nut.
Fig.7
Adjusting the riving knife (g. 8)
The saw is equipped with a riving knife suitable for saw blade diameters of 200 and 250 mm.
Always set the riving knife (1) close to the saw blade so that the gap never exceeds 4 mm. The riving
knife can be set in line with the saw blade by using the bolt (1) and the 3 adjustment screws (2). The
bolt only moves the riving knife longitudinally. The 3 adjustment screws (2) the riving aligns with the
saw blade.
Fig.8
the bolt
adjustment screws
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Robland HX260 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Robland HX260 in the language / languages: English, German as an attachment in your email.

The manual is 5,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Robland HX260

Robland HX260 User Manual - Dutch, French - 102 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info