592096
2
Zoom out
Zoom in
Previous page
1/18
Next page
3 4
English English
Never leave the appliance within the reach of children or unable persons.
In the event that you decide to dispose of the appliance, we advise you to make it
inoperative by cutting off the power cord. We also recommend that any parts that could be
dangerous be rendered harmless, especially for children, who may play with the appliance
or its parts.
Packaging must never be left within the reach of children since it is potentially dangerous.
Danger due to electricity
Check that the voltage indicated on the plate corresponds with that of the local network
before connecting the appliance to the supply mains.
Always plug the appliance into a grounded outlet.
Never leave the appliance unattended when it is connected to the electric network.
Always unplug the appliance when you fill the boiler tank with water.
This appliance is in conformity with directive 89/336 EEC relevant to electromagnetic
compatibility.
Danger of injury due to other reasons
Do not leave the appliance exposed to the weather (rain, sun, etc.).
Never direct the steam jet towards people, animals or devices that contain electrical parts
(e.g. the inside of an oven).
• Do not immerse the appliance in water or other liquids.
Do not use the appliance if it is damaged. Any repair work, including the replacement of the
power cord, must only be carried out by Qualified Service or authorized technicians - in
order to prevent any risk.
This appliance is intended for domestic use only.
Warning about burns/scaldings
CAUTION: danger of burns
• Do not touch hot surfaces while the appliance is being used. Allow the attachments to cool
down before replacing them.
• DO NOT OPEN THE SAFETY CAP WHILE THE APPLIANCE IS BEING USED.
ATTENTION: before unscrewing the cap, carry out the following operations:
- unplug the power cord from the outlet;
- slowly unscrew the cap and wait for a few seconds before unscrewing it completely.
Do not tilt the appliance more than 45° from its upright position while it is being used
inorder to prevent hot water from leaking out of the boiler Caution - material damage
The appliance is provided with a temperature regulator, a thermofuse and a safety plug. It
complies with European standards regarding electrical household appliances.
Before using the appliance, ensure that the objects, surfaces and fabrics to be cleaned are
resistant to or compatible with the high temperature of the steam.
In particular, follow the directions provided by the manufacturer and carry out a test on a
hidden part or a sample before using the appliance on cotto floors, wooden surfaces or
delicate fabrics such as silk and velvet.
When using the flexible pipe, before releasing the steam, direct the jet into a container so
as to remove the condensate from the pipe.
Never add descaling agents, aromatics, alcoholics or detergents to the water in the boiler -
they may damage the appliance or make it unsafe to use.
WARNING: do not use the glass-cleaning brush if the surface to be cleaned is very cold.
The change in temperature could cause the glass to crack. At times when temperatures are
particularly low, preheat the glass by directing steam over the whole surface to be treated
from a distance of about 40cm.
USING THE STEAMER
IMPORTANT! FILL THE BOILER TANK BEFORE USE!!
NEVER UNSCREW THE BOILER TANK’S CAP UNLESS YOU ARE SURE THAT THE
APPLIANCE HAS BEEN UNPLUGGED FROM THE OUTLET.
1) Unscrew the safety cap (1) and overturn the boiler tank to drain it completely.
2) Fill the boiler tank (figure A) with a measure (6) full of water by means of the funnel (5).
3) Screw the safety cap (1) on again.
4) To start the appliance, Insert the plug attached to the power cord into the outlet. The warning
light (7) will go on.
5) Wait about 3 to 4 minutes, then the steam will be ready. Press the button (4) to release
the steam.
Application of the attachments
Straight nozzle:
1) fully insert the attachment until it
stops up against the appliance’s body.
Align the mark on the nozzle with the
yellow mark on the appliance as shown
in figure B;
2) turn in a clockwise direction until
the mark on the nozzle is perfectly
aligned with the two lines on the
appliance’s body. Now the attachment
is blocked in the central position.
AC-109P is provided with an
articulated joint which allows the jet of
steam to be directed as desired:
insert the straight nozzle until it covers
the green round gasket, align the mark
on the nozzle with the mark on the
appliance’s body as shown in figure
B.
Turn in a clockwise direction until the
mark on the nozzle is perfectly aligned
and blocked.
B
A
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Roadstar SC-190P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Roadstar SC-190P in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info