744701
13
Zoom out
Zoom in
Previous page
1/20
Next page
|13
EN
12
Adding wood
Fill amount for heating up: 2 logs of max. total 2.5kg, depending on requirements.
The red flashing phase varies depending on the ambient influences between 5
and 10 min. If the combustion chamber door is opened, the display changes
to green flashing.
If the temperature increase is sufficient (wood added and lit), the display
changes to constantly green (the RIKATRONIC3 starts the burn-off control).
If an increase in temperature in not detected, the display changes, depending
on combustion chamber temperature, to the status prior to adding wood,
either to red flashing or to constantly red.
Burn out
If no more wood is added during the red flashing phase, the display changes
to constantly red. No more logs may be added from this point since ignition of
any logs added cannot be ensured. The stove must be heated up again.
ECO operation
If the room to be heated and the stove are already at temperature, continued
operation with lower heat output and log addition is possible.
Fill amount in ECO operation: 2 logs in total approx. 1.5kg
If the Eco key is pressed when adding wood (after closing the combustion
chamber door), the display changes to yellow flashing and Eco operation is
activated.
This operating mode also regulates the burn off with lower heat output to the
optimum.
If the Eco key is pressed again or the combustion chamber door is opened, the
display changes from yellow back to green and normal operation is activated
again.
Complete closing of the air flaps
The RIKATRONIC3 has a safety device that prevents the air flaps closing
completely during heating operation (hazard of deflagration). However the air
flaps can be closed completely with a sequence of ECO key and opening and
closing the combustion chamber door to stop the existing draught on stove
standstill.
Q Ensure that the stove has cooled down, is switched off and that the
combustion chamber door is closed
Q Plug in the mains plug and activate the main switch at the rear of the stove
Q Wait until the reference run has been completed and the display lamp is
constantly red
Q Now depress the ECO key for 5 sec with the combustion chamber door
closed until the display changes to yellow flashing
Q Open and close the combustion chamber door, the display is now constantly
yellow
Q The depress the Eco key again for 5 sec until a click is heard and the air
flaps close completely
As soon as the air flaps reach end position, the display goes off and the stove
can be switched off and the mains plug disconnected.
Power failure
In the event of a power failure the air regulation flap remains unchanged until the
fire goes out (no display). If mains voltage is available again after a brief power
failure, the display lights up as on start for 10 sec green and then changes to
red flashing due to the repeat reference run of the air flap motor.
If the temperature of the stove is still more than 80°C, the display changes and
the control system changes to the respective status. If the stove cools back
down during the power failure, the display changes to constantly red
Manual regulation
Note
Manual operation may only be performed with the unit switched off. Any other
procedure than that stated below may cause damage to components and
inevitably leads to loss of warranty.
Q Switch the stove off at the main switch and disconnect the mains plug.
Q Insert the socket spanner supplied sufficiently far into the sleeve as shown.
Turning clockwise opens the air flaps; anti-clockwise closes them.
Q Turn the socket spanner first to heating-up position (open until a stop is
detected).
Q Turn the socket spanner gradually anti-clockwise after the heating-up phase
to control the air intake and thus the burn-off manually.
Note
Always ensure that the stove is supplied with sufficient air for combustion;
otherwise increased smoke development may occur.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rika Tura at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rika Tura in the language / languages: English as an attachment in your email.

The manual is 7,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Rika Tura

Rika Tura User Manual - German - 20 pages

Rika Tura User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info