744704
13
Zoom out
Zoom in
Previous page
1/20
Next page
|13
EN
12
Warnings
Warning
Please close
W80
Position switch
open
W40
Burn back and
Flue Gas Flap open
Please Close
W40
Burn back or
flue gas flap
open
Please close
Meaning Der Ofen ist nicht in Betriebsposition�
Burn-back flap and flue gas flap are not
in heating position�
Burn-back flap and flue gas flap are not
in heating position�
Solution
Schieben Sie den Ofen in die richtige
Position und sichern Sie den Ofen�
Quit error message and enable
burn-back flap and flue gas flap�
Enable burn-back flap and flue gas
flap�
Warning
Please pull down lever
FLUE GAS FLAP
OPEN
W40
Please Wait
AIR FLAPS
ON CALIBRATION
W20
Meaning
The flue gas flap is not in heating
position�
After each power failure the air flaps
are calibrated anew�
The pressure ratio between installation
room and firebox does not allow further
operation�
Solution Close flue gas flap�
Wait until procedure is finished (up to 5
min)�
Quit error message and check the stove
for tightness (firebox door, cleaning lid),
disturbing factors in the installation
room (kitchen hood, windows closed,���),
as well as the flue�
Warning
W06
Firebox door and
Pellet container lid
open
Please close
Please close
W04
Firebox door
open
Pellet container lid
open
Please close
W02
Meaning
The combustion chamber door and/or
the pellet hopper lid are open�
The combustion chamber door is open� The pellet hopper lid is open�
Solution
Close combustion chamber door and/
or pellet hopper lid�
Close combustion chamber door Close pellet hopper lid�
Warning
Meaning
The connection from the mainboard to
the (radio) room sensor has been lost�
Solution
Check whether the (radio) room
sensor is correctly connected� Check
the control light of the receiver and
replace the batteries in the transmitter
if required�
If you deactivate the room sensor,
the Manual mode is automatically
activated�
NOT ENOUGH
LOW PRESSURE
check vacuum
W10
W01
Disable
Room sensor
Fault
Communication
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Rika Touch Display V2-27 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Rika Touch Display V2-27 in the language / languages: English as an attachment in your email.

The manual is 8,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Rika Touch Display V2-27

Rika Touch Display V2-27 User Manual - German - 20 pages

Rika Touch Display V2-27 User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info