626525
23
Zoom out
Zoom in
Previous page
1/28
Next page
GB
Z1209004. 5 GB
Enjoy the RIHO life-style
GB
GB
Whirlpool Electronic LCD user handbook
7.0 Exceptional maintenance
Attention: Always switch off the power supply before carrying out any maintenance
or other work.
The whirlpool service department cannot provide a service if there are no inspection hatches or the inspection hatches
are too small.
ATTENTION:
Always switch off the power supply before carrying out any maintenance or other work.
For extraordinary maintenance, please approach the authorised Service Centres. The guarantee will become void if
the product is used improperly by unauthorised personnel, and the manufacturer's liability for the safety of the product
will be cancelled immediately. If any parts fail, only use original and approved spares, otherwise the guarantee will
become void and the liability of the manufacturer for the safety of the product will be cancelled immediately.
Detecting and resolving problems.
Problem 1.
The whirlpool does not work when the on/off switch is pressed.
Cause 1:
Is the power supply to the whirlpool switched on?
Solution 1:
Is the whirlpool properly connected?
Check the fuses.
Is the power supply switched on?
Cause 2:
Is the water level high enough (bath full indication )?
The electronically controlled whirlpools are equipped with a level switch that only allows the system to operate if the
water level is high enough.
If sufficient water is available, check whether the water level switch has come loose during transport or installation
work.
Solution 2:
Top up the water if there is insufficient water.
If the level switch is not working, contact the Riho Service department.
Problem 2.
Not all hydrojets or floor jets have a powerful flow.
Cause 1:
In some electronically operated whirlpools the various jets can be switched on and off separately whilst the remaining
hydro jets are functioning.
Solution 1:
See basic function operation. With the or button the diverse combinations can be run through one after the other.
Solution 2:
Switch off the power, wait for a minute, then switch it on again, whereby the electronic system will be reset. If the
problem persists ring the service department.
6.0 Protection system
If there is insufficient water in the bath, the system will not switch on in order to prevent the pumps running dry. In
addition all motors are fitted with a thermal switch. These will switch off the motors in the event of problems.
6.1 Normal temperature of bath water.
The recommended normal temperature of bath water is 38°C.
6.2 Disinfection and cleaning.
Application of (Riho) Cleaning products; Cleaning liquid, Cleaning/disinfect tablets and Soda
Whirlpool Cleaning Products are for cleaning/disinfecting the Hydro System. An Aero system blows air only and
can't/doesn't need to be cleaned with a special product.
Two products;
1. Riho Cleaning Liquid
2. Riho Cleaning/disinfect Tablets (not available in Belgium)
3. Soda
The RIHO cleaning products are mild in composition and ideal to use in our RIHO whirlpools.
During normal use of the whirlpool it is advisable to clean it every 4 to 5 whirlpool turns, interspersed with cleaning
liquid and tablets. By little use of the whirlpool, it is advisable to clean the bath in advance, so that the system is clean
before using.
1. Clean Liquid / Cleaning Fluid (part number REDIS002)
This is for the cleaning of the hydro system. You fill the tub to just above the upper jets.
Fill the clean-tank with clean liquid. The whole bottle fits in the tank and lasts for 5 cycles.
Press the 2 outer drops on the keyboard simultaneously and keep them for a few seconds. The clean system
automatically turns on. After that, the whirlpool can be drained.
2. Cleaning Tablets (item number REDIS001)
Cleaning Tablets are to disinfect the Hydro System. You fill the tub to just above the upper jets. The first time you use
the Clean Tablets, add 5 tablets to the water (For subsequent sessions two / three tablets each time are sufficient).
Turn the Hydro system manually on and off (1 ½ to 2 minutes each time, repeat this 4-5 times for good flushing of all
tubes and hoses). After that, the whirlpool can be drained.
3. Major cleaning cycle with Soda
When you see black flakes in the water during the use of the whirlpool system we recommend cleaning with soda. Fill
the whirlpool just above the upper jet. Add a bag of soda to the water and make sure it is resolved because otherwise
it can cause scratches. Turn the Hydro system manually on and off (1 ½ to 2 minutes each time, repeat this 4-5 times
for good flushing of all tubes and hoses). This bath water can soak overnight so that it loosens stubborn dirt.
In the morning you repeat the process and you can empty the dirty water from your whirlpool.
For stubborn stains, the procedure may be repeated two or more times. The black flakes would be less at every turn
and eventually disappear.
Warning: The following points are essential when using Riho Clean/Disinfection tablets and Riho Clean Plus liquid:
- Keep the products out of reach of children.
- Avoid contact with the eyes and face.
- Not for internal use.
- In the case of skin contact, wash with water.
- Do not inhale.
- Do not sit in the bath after these products have been added.
-51--50-
6.3 Tips for users
- In case of health problems: Consult your doctor before using the whirlpool system.
- The maximum recommended duration for using the whirlpool is 10 minutes.
- The whirlpool system should not be used immediately after a meal.
- Bath foam (bubble bath), shampoos or soap should only be used after using the whirlpool system. If these media are
used prior to operation or when the Whirlpool bath is in operation, a great deal of foam will be generated.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Riho Whirlpool Electronic LCD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Riho Whirlpool Electronic LCD in the language / languages: English as an attachment in your email.

The manual is 4,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Riho Whirlpool Electronic LCD

Riho Whirlpool Electronic LCD User Manual - German, Dutch - 33 pages

Riho Whirlpool Electronic LCD Usermanual and installation guide - Dutch - 28 pages

Riho Whirlpool Electronic LCD User Manual - French - 33 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info