780484
11
Zoom out
Zoom in
Previous page
1/53
Next page
11
IDLE ADJUSTMENT
The idle adjustment is located on the carburetor under the right side of the gas tank. It is a white knob that is
pointing down and forward. Turning this knob clockwise (Facing the knob) will increase the idle RPM.
ATTENTION: ALWAYS ADJUST THE IDLE WHILE ENGINE IS RUNNING AND POSITIONED ON THE
MOTORCYCLE WITH HANDS ON THE BRAKES. THIS MOTORCYCLE IS AUTOMATIC AND WILL MOVE IF
IDLE IS SET TOO HIGH.
Because the motorcycle is automatic and the idle is neutral, the idle should be as low as possible. Adjust only
when the motor is warm and the choke is in the “in” (or “off”) position.
BRAKES
The front brake is a hand lever located on the right side handlebar. The rear brake is a foot operated lever located
above the right side floor board. The brakes are hydraulic disk type and require DOT 5 brake fluid.
ATTENTION: USING OTHER THAN DOT 5 BRAKE FLUID WILL CAUSE DAMAGE TO THE BRAKE SYSTEM.
USE ONLY DOT 5 FLUID.
STARTER SAFETY SWITCH
This vehicle is equipped with a starter safety switch which keeps the motorcycle from starting unless triggered. The
rear or front brake pedal must be depressed for the starter to operate. Once started, you may let off the rear brake
pedal.
TRANSMISSION
The transmission is completely automatic and has no controls. It is a CVT (continuously variable transmission) type
transmission and has no manual gears. It operates with a variable speed belt that is made of rubber. Incorrect
operation or abuse can shorten the normal operating life of the belt.
NOTE: The engine idles at 700 RPM, the transmission goes into gear at about 1200 RPM. That 500 RPM
difference is all you have before the motorcycle begins to move. NEVER APPLY THE BRAKES AND REV THE
ENGINE ABOVE TRANSMISSION ENGAGEMENT SPEED! This causes premature CVT belt wear and possible
drive clutch damage that is not covered under warranty.
KICKSTAND
The kickstand is located on the left side of the vehicle. The kickstand does not lock. DO NOT PARK THE
MOTORCYCLE ON A SLOPE.
HANDLEBARS
The handlebars on the Auto-Glide are 1” in diameter. They are rubber mounted to isolate vibration.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ridley Classic and TT Models at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ridley Classic and TT Models in the language / languages: English as an attachment in your email.

The manual is 3.04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info