104116
132
Zoom out
Zoom in
Previous page
1/155
Next page
130
Troubleshooting
Refer to the pointers listed below before submitting the equipment for repairs. If
the problem persists after trying the suggestions, contact your nearest Ricoh
service office.
Power Source
Problem
Power will not
come on
Power cuts out
Battery will not
charge
Battery quickly
consumed
Cause
Battery not loaded or battery
exhausted
AC adapter not properly connected
No operation performed so auto
power off function was activated
Battery exhausted
Battery at end of service life
Camera operated in extremely high
or low temperature environment
Camera operated in dark
environment requiring frequent use
of flash
Remedy
Insert battery correctly or charge battery.
Connect correctly.
Switch camera on again.
Charge battery.
Replace with new battery.
Page
P.15
P.16
P.18
P.24
P.15
P.16
Recording and Playback
Problem
Cannot confirm
shot image
No image on
LCD monitor
Cause
Battery not loaded or battery
exhausted
No power, or mode dial not set
Shutter release button not fully
pressed (pressed halfway)
CF card or PC card not formatted
No memory space on CF card or PC
card
No space in internal memory
CF card or PC card at end of
service life
Self-timer on
Flash charging
CF card or PC card contact surface
dirty
LCD confirmation time too short
No power or LCD monitor is dark
Video system is set on PAL and
video cable is still plugged in.
Remedy
Insert battery correctly or charge battery.
Switch on and set mode dial to recording
mode.
Press shutter release button all the way.
Format card.
Delete unnecessary files or insert new card.
Delete unnecessary files.
Insert new card.
Press
to disengage self-timer mode.
Wait until flash LED stops blinking.
Clean with soft dry cloth.
Increase LCD confirmation time.
Switch on and press DISPLAY button to
display image on LCD monitor, or adjust
monitor contrast using LCD contrast
adjustment buttons.
Set video system to NTSC or disconnect
video cable.
Page
P.15
P.16
P.25
P.55
P.43
P.20
P.112
P.112
P.20
P.67
P.56
P.120
P.28
P.49
P.87
P.88
P.119
Shutter release
button pressed
but no image
recorded
132


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ricoh RDC-I 700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ricoh RDC-I 700 in the language / languages: English as an attachment in your email.

The manual is 1,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info