288843
116
Zoom out
Zoom in
Previous page
1/134
Next page
114
Using the Remote Control
The DR-3 remote control unit (optional) makes it possible to record and play back
images from a remote location.
Important
Note
The remote control receiver is located on the right side of the lens.
Operate the remote control unit by pointing it at the remote control
receiver.
Note
• For instructions on replacing the batteries and maintaining the remote
control unit, refer to the accompanying manual.
• Some procedures differ when performed on the remote control unit and
on the camera itself. Follow the instructions below to use the remote
control unit.
Shooting
The remote control unit can be used to operate the camera. It is particularly
convenient when the camera is set up at a remote location or is in a fixed position.
q Set the mode dial to [ ] and press the
CARD/IN button to select a recording
destination.
w Decide the composition of the picture
and press the RELEASE button on the
remote control unit.
When the camera is set to the Still mode, the
self-timer lamp will blink and recording will start
approximately 2 sec. later. In the Continuous
mode, recording will start immediately after the
RELEASE button is pressed.
Note
• Use the zoom buttons to vary the size
of the subject. The
button
magnifies the subject (telephoto), while
the
button decreases the size of
the subject (wide angle).
RELEASE
ERASE
FWD
PROGR A M
EV
MULTI
RE V
ENTER
116


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ricoh rdc 5300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ricoh rdc 5300 in the language / languages: English as an attachment in your email.

The manual is 1,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info