This section describes the simple maintenance procedures you should follow to clean the filters, the lens, the cabinet, and to replace
the lamp and the filters.
❶ Cleaning the Filters
The air-filter sponge keeps dust and dirt from getting inside the projector and should be frequently cleaned. If the filter is dirty
or clogged, your projector may overheat.
WARNING
• Please do not use a spray containing flammable gas to remove dust attached to the filters, etc. Doing so may result in
fires.
NOTE: The message for lter cleaning will be displayed for one minute after the projector is turned on or o. When the message is displayed, clean the lters. The time to
clean the lters is set to [OFF] at time of shipment. (→ page 108)
To cancel the message, press any button on the projector cabinet or the remote control.
The two-layer filter on the projector improves cooling and dust-proof capabilities compared with the conventional models.
The outsides (the intake vent side) of the first and second layer filters remove dust.
To clean the filter, detach the filter unit and the filter cover.
CAUTION
• Before cleaning the filters, turn off the projector, disconnect the power cord and then allow the cabinet to cool. Failure to
do so can result in electric shock or burn injuries.
1. Press down on the buttons on the left and right and then pull the
filter cover towards you to open it.
The cover will open about 90 degrees before it stops.
Filter coverButton
When mounting the projector to a ceiling
The filter cover will open about 90 degrees before it comes to a stop
at the stopper position. Remove your hands as the stopper will be
detached if it is opened further. The filter cover will stop at a position
of about 90 degrees.
However, the filter cover may close if the projector vibrates.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Ricoh PJ WU6181N at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Ricoh PJ WU6181N in the language / languages: English as an attachment in your email.
The manual is 17,37 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.