1. First, press the (POWER) button on the projector cabinet
or the STANDBY button on the remote control.
The [POWER OFF / ARE YOU SURE ? / CARBON SAVINGS- SES-
SION 0.000[g-CO2]] message will appear.
2. Secondly, press the ENTER button or press the (POWER)
or the STANDBY button again.
The lamp will go off and the power supply will be cut. At this
point, if there are no input signals, the projector will go into the
standby mode after about 10 seconds. When in standby mode,
the POWER indicator will light red and the STATUS indicator will
light off when [NORMAL] is selected for [STANDBY MODE].
Power On
Steady blue light
Standby
Steady red light
Press twice
CAUTION:
Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if the AC power
supply is disconnected during normal projector operation.
Use caution when picking up the projector.
NOTE:
• While the POWER indicator is blinking blue in short cycles, the power cannot be turned o.
• You cannot turn o the power for 60 seconds immediately after turning it on and displaying an image.
• Do not unplug the power cord from the projector or from the power outlet while an image is being projected. Doing so could deteriorate the projector’s AC IN terminal
or the power plug’s contact. To turn o the AC power while an image is being projected, use the power strip’s switch, the breaker, etc.
• Do not disconnect the AC power supply to the projector within 10 seconds of making adjustment or setting changes and closing the menu. Doing so can cause loss of
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Ricoh PJ WU6181N at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Ricoh PJ WU6181N in the language / languages: English as an attachment in your email.
The manual is 17,37 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.