104070
25
Zoom out
Zoom in
Previous page
1/26
Next page
136136
Battery is exhausted, improperly
inserted or not loaded
Power is not turned on or mode
dial is not set
Shutter release button only
pressed halfway
SmartMedia memory card not
formatted
Insufficient memory on
SmartMedia memory card
Insufficient memory space in
internal memory
End of service life of SmartMedia
memory card
Card door open
Self-timer on
Flash is charging
A write protect pad is attached on
a SmartMedia memory card
SmartMedia memory card contact
surface dirty
Image confirmation time is too
short
Battery expired, improperly
inserted or not loaded
AC adapter (optional) not
connected correctly
Card door open
No buttons touched so auto
power off function was activated
Battery is exhausted
End of battery life
Camera operated in extremely
high or low temperature location
Camera operated in dark area
requiring frequent use of flash
Troubleshooting
Symptom Cause Remedy Page
Power will not
come on
Power cuts out
Battery will not
charge
Battery quickly
consumed
Insert the battery correctly or charge the
battery
Connect correctly
Close the card door and turn power on
again
Turn power on again
Charge battery or use AC adapter
(optional)
Replace with new battery
Recording
P.21
P.22
P.25
P.30
P.30
P.21
P.22
P.23
Shutter release
button pressed
but no image
recorded
Insert battery correctly or recharge
battery or use AC adapter (optional)
Turn power on and set mode dial to
shooting mode
Press shutter release button all the way
Format SmartMedia memory card
Erase unwanted files or insert new
SmartMedia memory card
Erase unwanted files
Insert new SmartMedia memory card
Ensure that card door is securely closed.
Press
button to disable the self-timer
Wait until flash LED ceases flashing
Remove the write protect pad from the
SmartMedia memory card
Clean contact surface with soft dry cloth
Set a longer image confirmation time
Symptom Cause Remedy Page
P.21
P.22
P.30
P.51
P.120
P.27
P.114
P.114
P.27
P.27
P.67
P.26
P.26
P.122
Refer to the items listed below before submitting the equipment for repairs. If the
problem persists, contact your nearest Ricoh service center.
Power Source
Cannot confirm
a shot picture
137
Appendix
Power is off, or LCD monitor is
dark
Dirty lens or AF viewfinder
Subject not in center of autofocus
field
Subject difficult to focus
Shooting mode is set to
(Sound), (Continuous
Shooting) or (Motion Picture)
Flash is set to
(flash off)
mode
Mode dial is set to macro mode
White balance set to mode other
than auto
Battery is exhausted
Subject farther than approx. 2.5m
Camera is too close to subject
Overexposed
Brightness setting needs
adjusting
Shot in low light area with camera
set to (flash off) mode
Under-exposed
Brightness setting needs
adjusting
Shooting conditions difficult to
achieve white balance in auto
mode
Screen display set to off
Brightness of autofocus field and
surrounding area are different, or
picture shot in a dark place
Phenomenon occurring with
pictures of bright subject, known
as smudge phenomenon
Autofocus is on
but camera not
focusing
Turn power on, or adjust brightness of the
LCD monitor with LCD LIGHT button
Clean lens or viewfinder with soft dry cloth
Use focus lock
Use focus lock or switch to manual focus
Set mode dial to
(Still Picture) or
(Text) mode
Press
button to cancel flash off mode
Press
button to cancel macro mode
Set white balance to auto
Charge battery or use AC adapter (optional)
Come closer to subject
Set flash to flash off mode with
button
Press
button to change exposure
compensation level or cancel the time
exposure mode
Press LCD LIGHT button to adjust
brightness of LCD monitor
Press
button to cancel flash off mode
Press
button to change exposure
compensation level or set the time
exposure mode
Press LCD LIGHT button to adjust
brightness of LCD monitor
Place a white object near the subject, use
the flash or select a white balance mode
other than auto
Press DISPLAY button to switch screen
display mode
There is no malfunction
There is no malfunction
Flash will not
fire or will not
charge
Image dark
even with flash
Image is too
bright
Unnatural
coloration of
image
Date and other
recording data
will not display
Symptom Cause Remedy Page
Image is too
dark
LCD monitor
brightness
changes during
AF operation
Vertical lines
appear on
image
No image on
the LCD
monitor
P.42
P.30
P.54
P.54
P.70
P.45
P.55
P.60
P.68
P.64
P.21
P.60
P.60
P.62
P.42
P.60
P.62
P.42
P.60
P.64
P.46
P.97
159
Appendix
INFORMATION TO THE USER
USA FCC Part15 Class B
The equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, user, and can radiate radio frequency energy and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. In this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. (FCC 15.105B)
Changes or modifications not expressly approved by the party responsible for
compliance could void the users authority to operate the equipment. (FCC 15.21)
Properly shielded and grounded cables and connectors must be used for connection
to a host computer in order to comply with FCC emission limits. (FCC 15.27)
An AC adapter with a ferrite core must be used for RF interference suppression.
COMPLIANCE INFORMATION STATEMENT
Product Name: DIGITAL CAMERA
Model Number: Caplio RR1
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
RICOH CORPORATION
5 Dedrick Place, West Caldwell NJ, 07006 Tel.: 1-800-225-1899
Note to Users in Canada
Note: This Class B digital apparatus complies with Canadian ICES-003
Remarque Concernant les Utilisateurs au Canada
Avertissement: Cet appareil numerique de la classe B est conforme a la norme NMB-
003 du Canada
IMPORTANT SAFETY INSTRUCTIONS-SAVE THESE INSTRUCTIONS DANGER-
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, CAREFULLY FOLLOW
THESE INSTRUCTIONS.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ricoh Caplio RR 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ricoh Caplio RR 1 in the language / languages: English as an attachment in your email.

The manual is 0,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ricoh Caplio RR 1

Ricoh Caplio RR 1 Additional guide - English - 16 pages

Ricoh Caplio RR 1 Additional guide - English - 6 pages

Ricoh Caplio RR 1 Additional guide - English - 24 pages

Ricoh Caplio RR 1 User Manual - English - 46 pages

Ricoh Caplio RR 1 Additional guide - English - 24 pages

Ricoh Caplio RR 1 User Manual - English - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info