788489
14
Zoom out
Zoom in
Previous page
1/17
Next page
26 27
Problem Possible Cause Solution
No power or lights to
REVITIVE when it is
switched on.
AC Adapter not switched on
at the electrical socket or AC
Adapter not plugged into device
properly.
Check electrical socket power
is switched on and the AC
Adapter is plugged into
the device correctly. If still
not working – contact your
authorized dealer.
REVITIVE is not
vibrating.
REVITIVE IS NOT DESIGNED TO
VIBRATE.
The IsoRocker is not
"rocking".
It is the muscles in your legs
that cause the "rocking",
THE ISOROCKER IS NOT
MECHANICAL.
The ISOROCKER will only rock
when increased to an intensity
which causes sufficient calf
muscle contraction. It may be
that you cannot comfortably
increase the intensity high
enough until you get used to the
sensation. It is important that
intensity is adjusted to a level
that is comfortable.
The device is too far in front
of you.
Sit with your knees at a 90
degree angle.
The IsoRocker system is not
enabled.
Ensure IsoRocker Disabler is
“flat”, in centre position (see
page 14).
My legs are aching
after treatment.
You may have the
intensity
on too high a setting and your
muscles are being overworked.
Leave adequate time after
each treatment to allow the
muscles to recover (just like after
vigorous exercise!). On your
next session start on a lower
setting (where you can feel the
mild electrical stimulation and it
is comfortable) and reduce the
duration until your muscles have
acclimatized to the stimulation.
When using the
IsoRocker on a hard
floor it makes a
tapping noise.
Incorrect positioning of the
device or too high an intensity
level.
Adjust the positioning of the
device or lower the intensity
level to reduce the device
tapping. Alternatively use a
floor mat under the device
to cushion the sound.
For more information including Frequently Asked Questions,
please visit www.revitive.com
Troubleshooting
Problem Possible Cause Solution
REVITIVE is on (lights
illuminated on the
LED display) but
I cannot feel the
electrical stimulation
through the foot-
pads.
Not placing both bare feet on the
foot-pads at the same time.
Ensure that your feet are bare
and each foot is placed on each
of the foot-pads at the same
time. Keep increasing the
intensity up to a maximum of 99
until you feel the stimulation.
Your feet may be dry. Moisturize the soles of your feet
to improve conductivity and
stimulation and try the procedure
again. You may also have to
increase the intensity level.
You may be dehydrated. Drink plenty of water before
and after using the device. The
device uses your body to create
the electrical circuit. Water is an
excellent conductor of electricity
and if your body is less hydrated
(below 60%) then the stimulation
may be less. Therefore it is
important to always remain well
hydrated.
The intensity level may be on
too low a setting.
This is a very safe device. Keep
increasing the intensity level
towards 99 until you feel the
stimulation. You may find that
you have to increase the
intensity level as you get used to
the therapy. The aim is not to get
to 99 but to find a setting that is
comfortable for you.
Body Pad cord is connected to
device. Disconnect the Body Pad cord -
the foot-pads will not work while
the Body Pad cord is plugged in.
If, having tried the solutions
above, you still cannot feel the
stimulation:
Test the device by placing one
hand across both foot-pads at
the same time (The heel end of
the foot-pads is easiest). With
your other hand, and starting
from zero, increase the
intensity level until you can feel
the stimulation. If you can feel
the stimulation through your
hand then the device is working.
If on 99 you still cannot feel the
stimulation then please contact
your authorized dealer.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Revitive Advanced at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Revitive Advanced in the language / languages: English as an attachment in your email.

The manual is 2.74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info