793469
9
Zoom out
Zoom in
Previous page
1/9
Next page
1. Remove the outer and inner chimney.
For the final assembly of the hood in exhaust air
operation, you need an exhaust grille with a 150mm
socket (a) for the connection of the exhaust air hose.
This is not included in the delivery.
Proceed as follows during assembly:
Mounting the hood for exhaust air operation:
Illustrations serve for illustration only
Attention! Be sure to observe chapter 11. "Installation" of user's manual.
The wall duct must be dimensioned for a 150 mm exhaust hose. (Drill hole about
155mm).
To mount the hood in exhaust air mode, mount it as described in the above chapter:
"Mounting the hood for recirculation mode:" , but without mounting the carbon
filters.
2. Mount the exhaust hose. (Fig. k)
3. Replace the outer and inner chimney shaft.
Fig. k)
(
a
)
fi200728ATL 4/4
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Respekta CH 99090 WA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Respekta CH 99090 WA in the language / languages: English, German as an attachment in your email.

The manual is 0.56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info