Manual Renkforce WS-WN530HP3-A (page 4 of 12) (English, German, Dutch, French)

796998

Zoom out

Zoom in

1/12

• Always observe the safety information and operating instructions of any other de-

vices which are connected to the product.

• Consult a technician if you are not sure how to use or connect the product, or if

you have concerns about safety.

• Maintenance, modications and repairs must be carried out by a technician or a

specialist repair centre.

• If you have questions which remain unanswered by these operating instructions,

contact our technical support service or other technical personnel.

b) Electrical safety

• The mains outlet must be located near to the device and be easily accessible.

• Only power the product using the power adapter provided.

• Only connect the power adapter to a normal mains socket connected to the public

supply. Before plugging in the power adapter, check whether the voltage stated on

the power adapter complies with the voltage of your electricity supplier.

• Never connect or disconnect power adapters if your hands are wet.

• Never unplug the power adapter from the mains socket by pulling on the cable;

always use the grips on the plug.

• When setting up the product, ensure that the cables are not pinched, kinked or

damaged by sharp edges.

• Always lay the cables so that nobody can trip over or become entangled in them.

This poses a risk of injury.

• For safety reasons, disconnect the power adapter from the mains socket during

storms.

• Do not touch the power adapter if there are any signs of damage, as this may

cause a fatal electric shock! Switch off the mains voltage to the socket containing

the power adapter (switch off the corresponding circuit breaker or remove the sa-

fety fuse, and then switch off the corresponding RCD protective switch). You can

then unplug the power adapter from the mains socket. Dispose of the faulty power

adapter in an environmentally friendly manner and discontinue its use. Replace it

with a power adapter of the same design.

c) Persons and product

• Never pour liquids over electrical devices or place objects lled with liquid next

to the device. If liquid or a foreign object enters the interior of the device never-

theless, rst power down the respective mains socket (e.g. switch off the circuit

breaker) and then pull the mains plug from the mains socket. Discontinue use and

take the product to a specialist repair centre.

• Never use the product immediately after it has been brought from a cold room into

a warm one. This may cause condensation to form, which can destroy the product.

Allow the product to reach room temperature before connecting it and putting it

into use. This may take several hours.

Controls

LAN /Bac kha ul

POE I N

Pai r 2S

Res et 6S

LAN 2 LAN 1

654321

1 LAN2 network connection

2 LAN1 network connection

3 Operating LED

(with wireless symbol)

4 PoE IN Ethernet connection

5 Pair Reset WPS button

6 ON/OFF button

Setup and installation

Ensure that no existing cables or pipes (including water pipes) are damaged when

drilling mounting holes or securing screws.

• Choose a suitable place for installation.

• Install the device on a ceiling or wall. Use the at-

tachments (dowels and screws) supplied.

• To do this, remove the base plate and use it as a

template to mark the mounting holes.

• Drill the size suitable for the dowels and insert

them.

• Screw on the base plate with the screws. On

some suitable surfaces, e.g. wood, you can

screw in directly without the dowels.

• The device can also be set up on a table or other

furniture.

• The PoE converter can be mounted or set up in

a suitable place in the same way using the two

lugs. The screws and other attachments required

for this are not included with the product.

Operating instructions

1200 AC Access Point

Item no. 2196498

Intended use

The product is used for creating and extending computer networks. It has 3 operating modes:

LAN bridge (AP mode), WiFi extender (repeater mode) and router.

‘LAN bridge (AP mode)’ mode creates a separate LAN network. ‘WiFi extender mode (repeater

mode)’ mode creates a separate WLAN network. ‘Router’ mode is used to connect devices

connected to the product to the internet using your existing modem with the same IP address.

Power is supplied via a PoE converter, which is supplied by a power adapter plugged into a

mains socket. The device functions are set via an HTTP web interface.

This product is intended for indoor use only. Do not use it outdoors. Contact with moisture (e.g.

in a bathroom) must be avoided under all circumstances.

For safety and approval purposes, do not rebuild and/or modify this product. Using the product

for purposes other than those described above may damage the product. In addition, improper

use can cause hazards such as a short circuit, re or electric shock. Read the operating instruc-

tions carefully and store them in a safe place. Only make this product available to third parties

together with its operating instructions.

This product complies with statutory, national and European regulations. All company names

Delivery content

• WLAN AP

• RJ45 cable (100 cm)

• Power adapter (24 V DC)

• PoE converter

• 3x screws

• 3x dowels

• Stand

• Operating instructions

Up-to-date operating instructions

Download the latest operating instructions at www.conrad.com/downloads or

scan the QR code shown. Follow the instructions on the website.

Explanation of symbols

The symbol with the lightning in a triangle indicates that there is a risk to your health,

e.g. due to an electric shock.

The symbol with an exclamation mark in a triangle is used to highlight important

information in these operating instructions. Always read this information carefully.

The arrow symbol indicates special information and tips on how to use the product.

This product must only be used in dry, enclosed indoor areas. It must not become

damp or wet, as this may cause a fatal electric shock!

This symbol indicates that this product is built according to protection class II. It is

equipped with reinforced or dual insulation between the mains circuit and the output

voltage.

This product has been CE tested and therefore complies with the necessary national

and European regulations.

Safety information

Read the operating instructions and safety information carefully. If you do not

follow the safety information and information on proper handling in these ope-

rating instructions, we will assume no liability for any resulting personal inju-

ry or damage to property. Such cases will invalidate the warranty/guarantee.

a) General information

• The device is not a toy. Keep it out of the reach of children and pets.

• Do not leave packaging material lying around carelessly. It may become a dange-

rous plaything for children.

• Protect the product from extreme temperatures, direct sunlight, strong jolts, high

humidity, moisture, ammable gases, vapours and solvents.

• Never expose the product to mechanical stress.

• If it is no longer possible to operate the product safely, stop using it and prevent

unauthorised use. Safe operation can no longer be guaranteed if the product:

- is visibly damaged,

- is no longer working properly,

- has been stored for extended periods in poor ambient conditions or

- has been subjected to any serious transport-related stresses.

• Handle the product carefully. Jolts, impacts or a fall even from a low height may

damage the product.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Renkforce WS-WN530HP3-A in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1.07 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Renkforce WS-WN530HP3-A Manual

Product: